FORD TRANSIT MK6 2000-2006 OSR REAR RIGHT EXTERIOR DOOR HANDLE F37B1022404BA

This listing is for a Ford Transit MK6 rear-right / offside-rear exterior door handle carrying manufacturer part number F37B1022404BA.

The component provides the hand-operated exterior release point for the rear door latch mechanism. Pulling the handle transfers movement through the mechanical linkage to release the door latch. Locking hardware, central-locking components and other door parts are separate unless specifically visible in the photographs.

Outer grip, pivots and mounting arrangement

Reverse-side construction and mounting plate

Mechanical mounting and release mechanism

Close-up of rear mechanism and fastener locations

D3FA, F3FA, ABFA, F4FA, D2FA, D2FB, D2FE and D4FA appear among the source listing's compatibility entries.

• Front-left or front-right exterior door handles.
• Rear-left / nearside-rear handles where the mounting or linkage orientation differs.
• Sliding-side-door handles unless every mounting and linkage detail matches.
• Tailgate or alternative rear-door mechanisms using a different handle architecture.
• Vehicles outside the source listing's verified 2000-2006 range solely because the handle looks similar.
• Mid-year production or body-conversion variants where the original stamped number or mounting geometry differs.

If your existing component carries a different suffix, bracket, pivot, cable/rod connection or fixing pattern, please verify before purchasing.

The following is general workshop guidance for an exterior mechanical door-handle replacement. Exact trim and fastener arrangements can vary by Transit body configuration.

1. Park safely, switch the vehicle off and open the applicable rear door.
2. Remove the inner trim panel or service cover carefully to gain access to the handle mounting area.
3. Photograph the existing release linkage before disconnecting anything so its routing and clip position are recorded.
4. Release the linkage rod/cable retaining clip carefully without damaging reusable clips.
5. Remove the handle's internal retaining nuts, bolts or fixing hardware.
6. Withdraw the old handle carefully through the exterior door opening.
7. Place both handles side by side and compare the manufacturer number, mounting points, pivots and release connection.
8. Transfer any serviceable seals or clips only where required and appropriate.
9. Insert the replacement handle, secure its mountings and reconnect the mechanical linkage.
10. Before closing the door, manually test the handle and latch repeatedly while the door remains open.
11. Confirm correct release, return action and locking operation, then reinstall the interior trim.

• Plastic trim-removal tools
• Ratchet and socket set
• Suitable Torx / screwdriver bits
• Small flat screwdriver or trim pick
• Socket extension
• Inspection torch
• Protective gloves
• Penetrating fluid if fasteners are corroded

Based on a planning estimate of 0.75 labour hour / approximately 45 minutes.

We want buyers to receive the correct component first time. Please compare all photographs, numbers and mounting details carefully before checkout.

Where a returned component has suffered diminished value because it has been handled, fitted, altered or damaged beyond what is reasonably necessary to inspect it, any permitted adjustment to the refund will be based on the actual condition and applicable eBay/consumer-law rules.

There is no automatic fixed restocking deduction simply because a buyer changes their mind. Please return components in the same condition in which they were supplied, with all supplied parts and identification markings intact.