MAZDA 3 BK 2004-2008 LEFT PASSENGER SUN VISOR GREY VANITY MIRROR NSF

MAZDA 3 BK 2004-2008 LEFT PASSENGER SUN VISOR

Grey front nearside visor with vanity mirror. No illumination lamps or electrical wiring are visible on the photographed item. Supplied as pictured.

Actual Item Photographs

These are images of the exact listing item and should take priority over generic catalogue wording when checking appearance, side, mirror type and mounting layout.

Actual item: grey visor face and vanity mirror cover.

Actual item: vanity mirror open. No mirror lamps are visible.

Actual item: rear surface, pivot mounting area and warning label.

Key fitment clue: photographed donor marking reads "MAZDA 3 2007 NSF visor".

Where This Part Fits

The visor mounts at the roof / headliner immediately above the left side of the windscreen in a right-hand-drive Mazda 3. In the UK this is the front passenger / nearside / NSF position.

LOCATION REFERENCE: visor mounts above the LEFT / PASSENGER side of the windscreen and headliner area

2007 Mazda 3 BK Vehicle Reference

The donor body style is not visible in the source listing, so we will not guess whether this individual part came from a hatchback or saloon. Both photographs below are model-family references only; fitment must be decided from the visor configuration and part-number evidence, not exterior appearance alone.

2007 Mazda 3 BK 5-door hatchback reference. Exterior reference only.

2007 Mazda 3 BK saloon reference. Exterior reference only.

Item Details and Engineering References

Compatibility and Fitment Table

Catalogue sources cross-reference the candidate visor number BN8P-69-320C-77 to Mazda 3 BK applications from 2004-2008. The photographed donor marking confirms 2007. Because the moulded number on this exact item is not readable, all years must still be matched by side, colour, mirror, roof specification and mounting configuration before ordering.

Buyer Matching Checklist - Reduce Wrong Orders

• Confirm your car is a Mazda 3 BK and check the exact model year.
• Confirm you need the LEFT / UK PASSENGER / NSF / NEARSIDE visor.
• Compare the exact grey shade and textile finish with your existing visor.
• Check that your existing visor uses a vanity mirror in the same position and style.
• Check whether your old visor has illumination lamps or an electrical plug. No such lamp or wiring is visible on this photographed part.
• Compare the outer pivot mount, inner retaining point and mounting-hole geometry.
• Locate and photograph the stamped / moulded number on your original part whenever possible.
• If anything differs, contact us through eBay Messages before ordering so fitment can be checked.

What the Sun Visor Does and Why Replacement Matters

The front passenger sun visor pivots down from the headliner to reduce direct sunlight and glare entering through the windscreen and side glass. This version also provides a covered vanity mirror. It is a mechanical interior component; no electrical lighting system is visible on the photographed unit.

Common Symptoms of a Faulty or Worn Visor

• Visor droops or will not stay securely in the stowed position.
• Loose or damaged pivot makes the visor swing unexpectedly.
• Broken retaining clip prevents the inner end from sitting securely.
• Cracked mirror, damaged mirror cover or missing trim.
• Rattles around the roof mounting area.
• Torn, heavily marked or delaminating fabric finish.
• Visor falls into the driver's or passenger's field of view and becomes an obstruction.

Fitting Guide

Estimated straightforward replacement time: approximately 10-20 minutes. This is a general guide, not a factory repair procedure. Fastener style and trim arrangement should be checked on your own vehicle before work begins.

Suggested Tools

• Plastic trim-removal tool.
• Small screwdriver or socket / driver that exactly matches the factory fastener head.
• Small non-marring pick or trim tool if required for a cover cap.
• Inspection torch.
• Clean gloves to protect the headlining.

General Replacement Steps

1. Park safely, switch the ignition off and move the visor into a position where it can be supported.
2. Release the free end of the old visor from its inner retaining clip.
3. Use a plastic trim tool to lift the outer pivot cover carefully if your vehicle uses a cover.
4. Identify the exact factory fastener head before choosing a driver. Do not force an incorrect tool into the screw.
5. Support the visor while removing the pivot fastener or fasteners.
6. If your vehicle reveals an electrical connector, stop and compare specifications before continuing: no lamp wiring is visible on this photographed replacement.
7. Place the old and replacement visor side by side. Check side, colour, mirror, pivot bracket, clip point and mounting geometry.
8. Fit the replacement bracket and tighten it securely using the vehicle manufacturer's service specification. Do not overtighten plastic trim or damage the headliner.
9. Refit any trim cap, reconnect the inner end and operate the visor through its full range of movement.
10. Confirm the visor stows securely, does not rattle and does not obstruct visibility.

Garage Labour Cost Guide - No Active Content

eBay descriptions do not support an active JavaScript calculator, so this listing uses a static labour matrix. Formula: hourly labour rate x 0.17 to 0.33 hours for an estimated 10-20 minute straightforward swap.

Fitting and Repair Service

Workshop Support Subject to Availability

We also offer fitting / repair support subject to workshop availability and the job being suitable for our service schedule.

• Ask through eBay Messages before travelling or purchasing specifically for fitting.
• Bring or send vehicle registration / VIN details and photographs of the existing part where possible.
• Fitment is far easier to verify when we can compare the old part number, mount and connector configuration.

Reference workshop image for illustration; it is not presented as a photograph of our premises.

Stock, Storage and Dispatch

Automotive parts reference image. Shows a stock assortment of vehicle components; not presented as our actual stock photograph.

Stock warehouse reference image. Illustrates high-volume storage; not presented as our actual premises.

Dispatch reference image. Illustrates boxed-goods preparation; not presented as our actual dispatch area.

Delivery and International Shipping

• UK delivery: choose from the postage options shown on the eBay listing / checkout.
• International delivery: available through the eBay international shipping programme shown at checkout. The current listing displays the Global Shipping Programme; destination eligibility is determined by eBay.
• Eligibility, postage charge, import charges and delivery estimates depend on destination, item restrictions and eBay checkout information.
• Address check: please make sure the delivery address shown at checkout is complete and correct before payment. Sellers generally cannot simply replace the checkout address after an order has been placed.

Returns, Fitment Responsibility and Condition

Please inspect the exact-item images before purchase. Cosmetic age-related marks, staining or wear visible in the photographs form part of the item's described condition. The component is supplied exactly as pictured unless the listing states otherwise.

• Use the fitment table and buyer checklist above before ordering.
• If unsure, ask for a fitment check through eBay Messages before purchase.
• Any return should come back in the same condition and with the same components as supplied, packaged adequately for transit.
• Where eBay policy permits, a deduction of up to 50 percent may be applied only to recover an actual loss in value when a returned item has been installed, altered, damaged, is incomplete or is inadequately packaged. This is not an automatic restocking fee.
• Nothing in this description removes statutory rights or protections available through eBay.

VAT Margin Scheme / Global Accounting

This second-hand vehicle component is sold under the applicable VAT Margin Scheme / Global Accounting treatment. VAT is not shown separately on the item price and no separately reclaimable VAT amount is stated for the sale.

Why Recycled Vehicle Parts Make Sense

Final Fitment Check Before You Buy