Nissan Pulsar C13 5DR 2014-2018 Trip Reset Dash Light Dimmer Switch 248243ZL0A
Nissan Pulsar C13 5DR 2014-2018 Trip Reset Dash Light Dimmer Switch 248243ZL0A
This component is the TRIP RESET / instrument-panel illumination brightness control. It is not the cruise-control switch. Cruise-control controls are located on the steering-wheel controls on applicable Pulsar models.
Nissan used specification changes and multiple electrical components within vehicle ranges. Do not order this switch from model name or registration year alone. The safest match is the vehicle VIN plus the number on the original switch.
• Nissan Pulsar European C13 / C13M five-door generation
• Vehicle model year falls within the 2014–2018 Pulsar range
• Existing switch number confirms 248243ZL0A / 24824-3ZL0A
• Front button symbols match: brightness − / + and TRIP RESET
• Rear electrical connector, pin arrangement and mounting tabs match the item photographs
• VIN / vehicle specification confirms the same switch where there is any uncertainty
| Make | Model | Body | Year | Fitment Rule |
|---|---|---|---|---|
| Nissan | Pulsar C13 / C13M | 5-door hatchback | 2014 | Only with confirmed 24824-3ZL0A + identical connector/buttons + VIN/specification check |
| Nissan | Pulsar C13 / C13M | 5-door hatchback | 2015 | Listing donor/reference year — still compare exact number, connector and VIN/specification |
| Nissan | Pulsar C13 / C13M | 5-door hatchback | 2016 | Only with confirmed 24824-3ZL0A + identical connector/buttons + VIN/specification check |
| Nissan | Pulsar C13 / C13M | 5-door hatchback | 2017 | Only with confirmed 24824-3ZL0A + identical connector/buttons + VIN/specification check |
| Nissan | Pulsar C13 / C13M | 5-door hatchback | 2018 | Only with confirmed 24824-3ZL0A + identical connector/buttons + VIN/specification check |
• Pulsar generations outside the European C13 / C13M five-door model family
• 2019–2026 simply because an automated compatibility table suggests those years
• Any C13 using a different switch number
• Any switch with different button symbols, electrical connector or mounting tabs
• Qashqai, Juke, X-Trail, Note, Micra or another Nissan merely because a switch looks similar
• Any other vehicle unless the exact part number is positively confirmed against the VIN / parts catalogue
Other vehicle cross-fitment: no additional Nissan model has been included because no sufficiently authoritative public Nissan part-number source was found confirming 24824-3ZL0A on another model. We prefer a smaller accurate compatibility chart to an inflated chart that causes returns.
Unsure? Please message us through eBay before purchase with your registration and preferably the full VIN. If possible also compare the number printed on the removed switch and the rear connector with the photographs above. Registration lookup alone should not be treated as conclusive where Nissan lists more than one component against a vehicle.
On a UK/right-hand-drive Nissan Pulsar C13, this control is located on the driver-side instrument panel beside the steering wheel. Nissan identifies it in the C13 driving-position layout as the TRIP RESET / instrument-panel brightness control.
TRIP RESET: used for the trip/odometer reset or display function where fitted.
BRIGHTNESS − / +: adjusts the illumination level of the meter/instrument panel.
Possible symptoms include:
✓ Trip display cannot be reset through the switch
✓ Instrument-panel brightness + / − controls fail to respond
✓ Intermittent operation when the button is pressed
✓ One side of the switch works while the other does not
✓ Button feels physically stuck, loose, sunken or damaged
✓ Visible damage to the connector or housing
Diagnostic note: wiring, connector damage, power supply, fuses or instrument-cluster faults can sometimes produce similar symptoms. Diagnose the circuit before replacing parts unnecessarily.
| Brand | Nissan |
| Part Type | Trip Reset / Instrument Panel Brightness Control Switch |
| Manufacturer Number | 248243ZL0A |
| Search Formatting | 24824-3ZL0A |
| Condition | Used |
| Colour | Black |
| Construction | Moulded automotive plastic housing with internal electrical switching/contact components; exact polymer grade not marked/verified |
| Mounting Area | Driver-side dashboard / instrument panel |
| Warranty | 30 days, subject to the listing terms |
A factory Nissan component was designed around the vehicle's original connector, switch feel, mounting arrangement, electrical specification and dashboard appearance. An inexpensive unverified copy may look similar externally while differing in connector quality, button travel, internal contacts or mounting tolerance.
Buying a good used original component can therefore provide a cost-effective way of keeping the vehicle close to its original specification while also avoiding the waste involved in replacing a complete assembly unnecessarily.
Important: the best part is still the correct part. Always confirm the number and VIN before purchasing.
The following is a general fitting outline rather than a substitute for the Nissan workshop manual. Trim fastening arrangements may vary by specification.
2. Switch the ignition fully OFF, remove the key / keep the intelligent key away from the work area and follow the correct workshop procedure for electrical work.
3. Protect surrounding dashboard trim with suitable trim tape or a soft cloth.
4. Using a non-marring plastic trim tool, carefully release the relevant driver-side dash/switch trim. Do not force clips.
5. Release the electrical connector locking tab and disconnect the existing switch.
6. Compare old and replacement units side-by-side: 24824-3ZL0A, button markings, mounting tabs and rear connector must agree.
7. Connect the replacement switch and refit the trim securely.
8. Switch ignition ON and test TRIP RESET plus instrument illumination − / + operation before completing the job.
• Non-marring plastic trim-removal tools
• Trim protection tape / soft cloth
• Torch or inspection light
• Small pick only where required to release an electrical connector lock
• Suitable screwdriver/socket only if your particular trim panel has mechanical fasteners
• Multimeter for diagnostic work where appropriate
Planning estimate only: approximately 0.25–0.50 labour hour for a straightforward switch change by a competent technician where no additional diagnosis, damaged trim or wiring repair is required. This is not represented as an official Nissan flat-rate time.
Formula: Garage labour cost = hourly labour rate × labour time.
| Garage Rate | 15 min / 0.25 hr | 30 min / 0.50 hr |
|---|---|---|
| £50 / hour | £12.50 | £25.00 |
| £75 / hour | £18.75 | £37.50 |
| £100 / hour | £25.00 | £50.00 |
| £125 / hour | £31.25 | £62.50 |
| £150 / hour | £37.50 | £75.00 |
Labour figures exclude diagnosis, additional repairs, consumables and any VAT charged by the fitting garage.
A substantial range of used vehicle components held in stock and on the shelf at any one time.
Fitting and repair services are available on selected jobs, subject to workshop availability and prior arrangement.
Parts are prepared for dispatch with the aim of protecting connectors, mounting points and fragile components during transit.
How to find us / WhatsApp
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
UK delivery is available in accordance with the postage service shown on the eBay listing. For international buyers, eBay's Global Shipping Programme may be available only where eBay offers it for this item and destination at checkout. International taxes, customs charges and programme charges are determined by eBay / the destination rules where applicable.
EU:
Austria • Belgium • Bulgaria • Croatia • Cyprus • Czech Republic • Denmark • Estonia • Finland • France • Germany • Greece • Hungary • Ireland • Italy • Latvia • Lithuania • Luxembourg • Malta • Netherlands • Poland • Portugal • Romania • Slovakia • Slovenia • Spain • Sweden
Non-EU:
Antigua and Barbuda • Aruba • Australia • Bahamas • Bahrain • Bangladesh • Barbados • Belize • Bermuda • Bolivia • Brazil • Brunei Darussalam • Cambodia • Canada • Cayman Islands • Chile • China • Colombia • Costa Rica • Dominica • Dominican Republic • Ecuador • Egypt • El Salvador • French Guiana • Grenada • Guadeloupe • Guatemala • Guernsey • Honduras • Hong Kong • Iceland • Indonesia • Israel • Jamaica • Japan • Jersey • Jordan • Kuwait • Liechtenstein • Macau • Malaysia • Maldives • Martinique • Mexico • Monaco • Montserrat • New Zealand • Nicaragua • Norway • Oman • Pakistan • Panama • Paraguay • Peru • Philippines • Qatar • Reunion • Saint Kitts and Nevis • Saint Lucia • Saudi Arabia • Singapore • South Africa • South Korea • Sri Lanka • Switzerland • Taiwan • Thailand • Trinidad and Tobago • Turks & Caicos Island • UAE • Ukraine • Uruguay • USA • Vietnam
Destination eligibility can change and eBay checkout is the final authority. The listing must be enrolled/configured for the applicable international postage programme.
Customers must ensure the delivery address shown at eBay checkout is complete and correct before payment. For transaction security and marketplace compliance, an address cannot simply be changed after checkout. If an address is incorrect, use the appropriate eBay process rather than asking for the parcel to be redirected off-platform.
This listing currently provides a 30-day return period. Please use the photographs, part number, connector and compatibility guidance above before installation.
Returns are handled through the applicable eBay return process. If an eligible returned item comes back used, altered, damaged, incomplete or in a materially different condition, any permitted reduction in refund will be assessed through eBay's rules and only to the extent allowed by those rules.
If you are uncertain about compatibility, please ask for fitment verification before fitting the part.
This used part is sold under the applicable VAT Margin Scheme / Global Accounting arrangements. VAT is not shown separately on a margin-scheme sale and is not separately reclaimable by the purchaser.
Choosing a serviceable used component keeps an existing part in productive use and can reduce demand for unnecessary replacement assemblies, packaging and disposal. It also supports an independent local automotive business, skilled parts identification and the circular reuse of vehicle components. Thank you for choosing ThePartPilot.