This unit is for vehicles fitted with the factory ultrasonic interior alarm system. Before ordering, compare the complete shape, twin sensor grilles, grey trim colour, mounting tabs and every electrical connector with your original part. For the highest-confidence check, send your full 17-character VIN and clear photos of your existing module through eBay Messages.
Exact Item Photographs
These images are hosted on eBay's own image servers and show the actual used assembly offered in this listing. Cosmetic marks are possible because this is a used interior component.
Vehicle Fitment Guide
| Vehicle | Body / chassis | Years | Fitment status | Required checks |
|---|---|---|---|---|
| Nissan Qashqai I | 5-door SUV / J10 or NJ10 | 2007-2010 pre-facelift | Conditional fit | Factory ultrasonic alarm; same trim colour, grilles, tabs and connectors; VIN/OE number match |
| Nissan Qashqai I | 5-door SUV / J10 or NJ10 | 2010-2013 facelift | Conditional fit | Factory ultrasonic alarm; same trim colour, grilles, tabs and connectors; VIN/OE number match |
| Nissan Qashqai+2 I | 5-door, 7-seat SUV / JJ10 | 2008-2010 pre-facelift | Conditional fit | Factory ultrasonic alarm; same roof-module design and connectors; VIN/OE number match |
| Nissan Qashqai+2 I | 5-door, 7-seat SUV / JJ10 | 2010-2013 facelift | Conditional fit | Factory ultrasonic alarm; same roof-module design and connectors; VIN/OE number match |
Important: Engine size and gearbox are not the primary fitment determinants for this roof alarm component. Alarm specification, production date, trim colour, connector layout and OE reference are more important. Some vehicles built in late 2006 may be registered as 2006; these must be checked by VIN rather than added automatically to compatibility.
Known non-fitments / do not assume compatibility
Nissan Qashqai II J11, normally 2014 onward.
Nissan Qashqai III J12, normally 2021 onward.
Vehicles without the factory ultrasonic interior alarm option.
Any unit with a different connector, trim colour, grille layout, mounting tabs or OE number.
Part Number Information
Commonly associated complete-assembly references:
28435-JD1028435JD1028435-JD10A28435JD10ASensor/component references seen on matching assemblies:
28336-EB00A28336BEB00AVerification warning: the current listing photographs do not show a clearly readable OE label. Treat these as cross-reference numbers only until the number is physically checked on the stock item. Never order solely from a similar-looking marketplace listing.
Where It Fits and What It Controls
This assembly is normally clipped into the front upper interior/headlining area near the front overhead console or rear-view mirror zone. Exact access varies by trim specification, so compare the installed part before removal.
Function
Uses ultrasonic transducers to monitor movement or air disturbance inside the locked passenger compartment and reports intrusion activity to the vehicle's alarm/security system.Construction
Moulded interior-grade grey plastic trim, integrated low-voltage ultrasonic transducers, wiring/connectors, foam anti-vibration material and clip-style mounting features.Possible Fault Symptoms
The alarm may sound when no clear intrusion is present.
The perimeter alarm may arm, but movement inside the cabin is not detected.
Loose connections, moisture, corrosion or internal sensor failure can cause inconsistent behaviour.
Broken grilles, trim, clips or wiring can prevent correct mounting or operation.
Alarm faults can also be caused by bonnet switches, door/boot switches, battery-voltage issues, wiring faults or control modules. Diagnostic testing is recommended before replacing parts at random.
Why Choose an Original Factory-Fitted Used Part?
Correct physical design
When the OE reference matches, the original factory part offers the best prospect of matching the connector keying, roof-trim contour, clip positions and sensor arrangement.Cost and sustainability
Selected used parts may save up to 70% compared with equivalent new dealer pricing. Actual savings vary by part, availability and new-part price.A low-cost copy may look similar but can differ in sensitivity, connector design, housing dimensions or trim finish. Match the OE reference and photographs rather than choosing on price alone.
Fitting Guide
Typical tools
Plastic trim-removal leversSmall trim pickTorch10 mm spanner if battery isolation is requiredDiagnostic scan tool if fault codes remainTypical replacement procedure
- Park safely, switch the ignition off, remove the key from the vehicle and allow electronic systems to enter sleep mode.
- Follow the vehicle manufacturer's battery-isolation procedure where required. Be aware that battery disconnection can affect radio settings, windows and learned values.
- Use plastic trim tools to carefully release the front roof/overhead trim surrounding the existing sensor. Do not crease the headlining.
- Support the trim, release the electrical connector locking tabs and unplug by holding the connector body — never pull the wires.
- Before installation, compare the old and replacement units side by side: OE number, trim colour, overall shape, grille pattern, tabs, plug count and connector keying.
- Connect the replacement module, locate all tabs correctly and press the trim into place without forcing it.
- Restore the electrical supply where applicable. Clear stored fault codes if required and test the alarm according to the vehicle handbook.
Estimated workshop time: approximately 0.5 to 0.75 hour for a straightforward replacement by an experienced technician. Extra time may be needed for diagnosis, damaged clips, wiring repairs, unusual trim access or alarm-system testing.
Static Garage Labour Cost Guide
eBay descriptions cannot use JavaScript or an interactive calculator. Use the simple formula hourly rate × labour time. The table below shows estimated labour only and excludes diagnostics, VAT, consumables and additional repairs.
| Garage hourly rate | 0.5 hour | 0.75 hour | 1.0 hour |
|---|---|---|---|
| £60 per hour | £30 | £45 | £60 |
| £80 per hour | £40 | £60 | £80 |
| £100 per hour | £50 | £75 | £100 |
| £120 per hour | £60 | £90 | £120 |
| £150 per hour | £75 | £112.50 | £150 |
Fitting and diagnostic services may be available through ThePartPilot subject to technician availability and prior appointment. Please enquire through eBay Messages before travelling.
Ordering Checklist — Reduce Wrong Orders
- Confirm your model is first-generation Qashqai J10/NJ10 or Qashqai+2 JJ10.
- Confirm the vehicle has the factory ultrasonic interior alarm system.
- Compare every listing photograph with your original module.
- Match trim colour, twin grille layout, overall shape, clips, wiring and connectors.
- Match the complete OE number where it is visible.
- For verification, send the full 17-character VIN and clear photos through eBay Messages before ordering.
- Ensure the delivery address at eBay checkout is complete and correct. We cannot redirect or change the address after payment.
Condition, Supply and Warranty Notes
Delivery, Collection and VAT
UK and international delivery
International delivery is available to eligible destinations through eBay's current international shipping programme. Destination availability, import charges, taxes and final delivery cost are calculated by eBay at checkout and can vary by item and buyer location.How to find us / WhatsApp
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
VAT margin / global accounting scheme
This used item is sold under the applicable VAT margin/global accounting scheme. VAT is not shown separately on the invoice and is not reclaimable as input tax.Large stocked range
ThePartPilot holds more than 25,000 used vehicle parts in stock at any one time, subject to normal stock movement.Returns and Fitment Responsibility
Supporting a Local Small Business and Reusing Parts
Accuracy note: This description is based on the photographed item and commonly associated Qashqai J10/JJ10 cross-references. A readable stock-item label and VIN-level parts-catalogue check are required before claiming unconditional compatibility or entering an OE number as a confirmed MPN.