Vauxhall Meriva B 2010-2017 NSR Left Inner Tailgate Bootlid Rear Light 21629003
Vauxhall Meriva B 2010-2017 NSR Left Inner Tailgate Bootlid Rear Light 21629003
Vauxhall Meriva B 2010–2017 NSR Left Inner Tailgate / Bootlid Rear Light
Primary identification number: 21629003
Used original factory component • Actual item photographed • UK stock
Actual Part Photographs
These are photographs of the listed component. Please compare the lens shape, rear housing, plug, mountings and identification markings with your existing lamp.
THEPARTPILOT
THEPARTPILOT
THEPARTPILOT
THEPARTPILOT
Where This Part Fits On The Vehicle
This lamp sits in the left-hand inner section of the tailgate/bootlid. On a UK right-hand-drive Vauxhall, left is the passenger or nearside. The highlighted area below shows the installation position on a 2011 Vauxhall Meriva B 5-door MPV.
LEFT INNERTAILGATE LAMP
Reference vehicle photograph only. The sale is for the lamp shown in the actual product photographs, not the vehicle.
Verified Compatibility Table
| Make | Model / Generation | Years | Body | Engines / Gearboxes | Fitment note |
|---|---|---|---|---|---|
| Vauxhall | Meriva B / Mk2 / S10 | 2010–2017 | 5-door MPV | All petrol, diesel and LPG variants; manual and automatic | Left/passenger/nearside inner lamp mounted in tailgate. Match the actual photos and connector. |
| Opel | Meriva B / S10 | 2010–2017 | 5-door MPV | All engine families | Body fit is shared, but confirm the left-inner reference, bulb carrier and market lighting specification before ordering. |
- Vauxhall Meriva A / Mk1, including earlier vehicles registered in 2010
- Right-hand / driver / offside inner tailgate lamp
- Left or right outer rear lamp fitted to the body quarter panel
- Astra, Corsa, Zafira, Mokka or any other Vauxhall model
- Any vehicle with a different connector, mountings, lens pattern or existing reference
- Any 3-door application — Meriva B is a 5-door MPV
Identification & Cross-Reference Guide
Reference numbers found within the Meriva B left-inner tailgate-lamp family include:
21629003 21620101 13434861 13435485 0284521168 1222477 1222231 13260838 13307491
Five checks before purchase
- Confirm your car is a Meriva B / Mk2 / S10, not a Meriva A.
- Stand behind the car and confirm you need the left/passenger/nearside inner tailgate lamp.
- Compare your lens shape and red/clear layout with the actual photographs.
- Compare the rear connector, bulb-carrier area and fixing locations.
- Send your registration, VIN and a clear photograph of your existing lamp through eBay Messages if uncertain.
What The Lamp Does
This tailgate-mounted rear combination lamp forms part of the vehicle's rear visibility and signalling system. For the left-inner Meriva B lamp family, catalogue data identifies the reverse-light and rear-fog-light functions. It is not the outer brake/indicator lamp. Bulb-carrier and market specification should still be matched to the old unit before installation.
Material descriptions are based on moulded markings visible on the item. Bulbs are service consumables and are not guaranteed unless specifically stated as tested in the listing.
Common Fault Symptoms
- Reverse or rear-fog function does not illuminate after bulb and fuse checks
- Persistent condensation or water inside the lamp
- Cracked lens, broken mounting point or impact damage
- Corroded bulb contacts, burnt holder or intermittent connection
- Dashboard bulb warning or repeated bulb failure
- Reduced rear visibility or an MOT lighting defect
Why Choose A Used Original Factory Part?
Cheap copies can differ in lens colour, sealing, plug quality, mounting accuracy and long-term durability. A clean used original part is often the most direct replacement, provided the buyer carefully matches the reference, connector and photographs.
Fitting Instructions
Estimated fitting time: approximately 20–40 minutes for a competent technician. Allow longer if trim clips are seized, wiring is damaged or diagnosis is required.
Typical tools
Trim removal tool 8mm / 10mm socket or small spanner T20 / T25 Torx if trim requires it Gloves Clean cloth
- Park safely, apply the handbrake, switch the ignition and exterior lights off, and open the tailgate.
- Remove the relevant inner access flap or tailgate trim carefully with a plastic trim tool.
- Support the lamp, disconnect the electrical plug and inspect the connector for heat damage or corrosion.
- Undo the retaining nuts or fixings. Keep pressure even and do not force plastic studs.
- Withdraw the lamp from the outside of the tailgate without levering against painted panels.
- Transfer the correct bulb carrier or serviceable bulbs only where required, and check the foam seal and mating surface.
- Position the replacement lamp, engage all guides, hand-tighten the fixings evenly and avoid overtightening.
- Reconnect the plug and test reverse and rear-fog functions before refitting the trim.
Garage Labour Cost Estimator — No Active Content
Use the table below as a simple static guide. Calculation: hourly labour rate × booked labour time.
| Booked time | £50/hour | £70/hour | £90/hour | £120/hour |
|---|---|---|---|---|
| 0.3 hour | £15 | £21 | £27 | £36 |
| 0.5 hour | £25 | £35 | £45 | £60 |
| 0.7 hour | £35 | £49 | £63 | £84 |
Illustrative labour only. Diagnosis, seized parts, wiring repair, bulbs, trim clips, VAT treatment and local garage rates may alter the final quote. Fitting or repair support may be available subject to capacity; ask through eBay Messages.
Stock, Workshop & Dispatch
More than 25,000 used vehicle parts are held in stock at any one time. The photographs below are licensed illustrative stock images and are not photographs of our premises; they show the type of parts storage, workshop support and packing process described.
Illustrative image — not our actual warehouse
Subject to availability; illustrative image — not our garage
Illustrative image — not our dispatch centre
Delivery, Collection & Checkout Address
- UK dispatch: packed to protect the lens, mountings and plug during transit.
- Worldwide delivery: available through eBay's international shipping programme where the item and destination are eligible. The countries, delivery charge, customs amount and estimated date displayed by eBay at checkout are authoritative.
- Collection: available by prior appointment through eBay Messages, seven days a week up to 8pm, including bank holidays where specifically confirmed in advance.
-
How to find us / WhatsApp
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Returns & Fitment Responsibility
Please use the photographs, generation, side, location, connector and reference-number guide before ordering. eBay's vehicle compatibility tool is useful guidance, but the actual part comparison is the final check for a used component.
- Return the same supplied item with all identification marks intact and all included components.
- Incorrectly ordered or no-longer-required returns are handled under the return settings shown on the eBay listing.
- Any deduction permitted for a returned item can only reflect the actual reduction in value caused by fitting, damage or handling beyond what is reasonably necessary to inspect it; no automatic fixed deduction is stated.
- Faulty, damaged or not-as-described claims are handled under eBay Money Back Guarantee and applicable statutory rights.
- Labour, diagnostic and consequential costs are not included in the parts sale unless separately agreed in writing.
VAT Information
Global Accounting VAT Margin Scheme: where this used item is eligible and sold under the scheme, VAT is accounted for within the margin and is not shown separately or reclaimable by the buyer.
Support A Small Business & Reuse Quality Parts
🚗 Support independent automotive recycling. Choosing a serviceable used component can extend the useful life of an existing part, reduce demand for a newly manufactured replacement and keep reusable material in circulation.
♻️ Every correctly matched reused part helps reduce waste. Thank you for supporting a local small business and for taking the time to verify fitment before ordering.