Vauxhall Meriva B MK2 2010-2017 Front Left Seat Belt 13305707 34040558
Vauxhall Meriva B MK2 2010-2017 Front Left Seat Belt 13305707 34040558
Vauxhall Meriva B MK2 2010–2017 Front Left Passenger Seat Belt
TRW 34040558 • GM/Vauxhall references F 13305707 and N 13250509 • Black front-left inertia-reel assembly with SRS pretensioner connection
SEO Listing Title
70 characters. High-value terms are placed first: make, model, generation, exact years, position, product and both principal reference numbers.
What You Are Buying
A used original factory-fitted front-left three-point seat-belt and inertia-reel assembly removed from a Vauxhall/Opel Meriva B. The exact item and its identifying labels are shown below.
Included: only the belt/retractor assembly and attached components visible in the item photographs. The seat-belt buckle, interior pillar trim, mounting bolts and other SRS components are not included unless clearly photographed.
Position on the Vehicle
Mounted behind the front-left centre/B-pillar trim. On a UK right-hand-drive Vauxhall this is the front passenger / nearside / NSF position. On a left-hand-drive Opel, front-left is the driver's side.
The belt routes from the lower retractor, through the upper guide and across the occupant to the buckle beside the seat.
Exact Item Photographs
THEPARTPILOT
THEPARTPILOT
THEPARTPILOT
THEPARTPILOT
THEPARTPILOTCorrect Vehicle and Fitting Location
Verified Identification and Compatibility
| Make / Model | Years | Body | Position | Compatibility requirement |
|---|---|---|---|---|
| Vauxhall Meriva B / Mk2 / S10 | 2010–2017 | 5-door MPV | Front left; UK passenger / nearside / NSF | Match F 13305707, N 13250509 and/or TRW 34040558, plus connector, pretensioner and mountings. |
| Opel Meriva B / S10 | 2010–2017 | 5-door MPV | Front left; driver side on most LHD vehicles | Cross-market equivalent body only. Buy only after exact label and configuration match. |
Engine note: this is a body-restraint component rather than an engine component. The current eBay structured compatibility data identifies Meriva B entries for 1.4 petrol A14XER/B14XER and 1.7 CDTi A17DT across 2010–2017. Other Meriva B engine versions must not be assumed compatible: match the physical unit and label references.
Part Numbers and Specification
Will Not Fit
- Vauxhall Meriva A / Mk1, approximately 2003–2010.
- Front-right / UK driver-side belts, rear belts or centre belts.
- Astra, Corsa, Zafira, Mokka or other Vauxhall/Opel models merely because a connector looks similar.
- Any Meriva B with different label numbers, connector keying, pretensioner arrangement, mounting points or webbing specification.
- Any unit that has deployed, locked after collision damage or is subject to a safety recall.
Best check: send the VIN and a clear photograph of your existing label and connector through eBay Messages before ordering. Visual and part-number matching takes priority over generic item specifics.
Common Fault Symptoms
- Belt retracts slowly, unevenly or not at all.
- Webbing will not pull out or stays permanently locked.
- Frayed, cut, heat-damaged, contaminated or twisted webbing.
- Cracked housing, bent bracket or abnormal retractor noise.
- SRS/airbag warning lamp caused by a pretensioner circuit fault.
- Damaged plug, wiring or connector lock.
- Post-collision pretensioner deployment or a locked mechanism.
- Belt fails to latch correctly; note that the separate buckle may be the cause and is not normally included here.
Why Replace It with an Original Factory Part?
A seat belt is a safety-critical restraint component. An original factory part is designed around the vehicle's mounting geometry, webbing length, reel angle, connector keying and restraint-system specification. A cheap universal copy may look similar but can have different mounting, electrical or locking characteristics.
Buying a correctly identified used original component can provide factory fit and substantial value compared with buying new. Savings can reach up to 70% in some cases, depending on the part and current new retail price. Actual savings vary.
Fitting Guidance — Safety-Critical SRS Component
Suggested Tools
Battery-terminal tool, trim-removal tools, appropriate Torx and socket set, ratchet, calibrated torque wrench, suitable scan tool for the SRS system, protective gloves and eye protection.
Outline Procedure
- Confirm the replacement label numbers, connector and mounting arrangement against the removed unit.
- Switch the ignition off, remove the key and disconnect the negative battery terminal. Wait the manufacturer-specified SRS discharge time in the workshop manual.
- Move the front seat as required and carefully remove the left sill and B-pillar trim without damaging clips or curtain-airbag areas.
- Release the connector's secondary lock and disconnect the pretensioner plug correctly. Never probe an SRS connector with a test light or ordinary multimeter.
- Remove the lower anchor, upper guide/height-adjuster connection and retractor fasteners while supporting the assembly.
- Install the replacement in the original routing with no twists. Tighten every safety-restraint fastener to the exact workshop-manual torque; no guessed torque values should be used.
- Refit the trim, reconnect the battery, perform the prescribed SRS diagnostic check, verify the warning lamp sequence and test smooth pull-out, locking, retraction and latching.
Estimated workshop time: approximately 0.8–1.5 hours, depending on trim access, seized fasteners and diagnostic requirements. This is an estimate, not a fixed quotation.
Static Garage Labour Cost Guide
No active content or JavaScript is used. Calculate labour by multiplying the garage's hourly rate by the estimated 0.8–1.5 hours.
| Garage rate | 0.8 hour | 1.0 hour | 1.5 hours |
|---|---|---|---|
| £50 per hour | £40 | £50 | £75 |
| £60 per hour | £48 | £60 | £90 |
| £70 per hour | £56 | £70 | £105 |
| £80 per hour | £64 | £80 | £120 |
| £90 per hour | £72 | £90 | £135 |
| £100 per hour | £80 | £100 | £150 |
| £120 per hour | £96 | £120 | £180 |
Labour only. Diagnostic charges, replacement clips, consumables, taxes and additional repairs may be extra. Fitting and general repair services may be available subject to technician capacity and prior arrangement through eBay Messages.
Condition, Safety and Ordering Checklist
- Used item: age-related marks and storage signs may be present. Study every item photograph.
- Confirm the belt has not been deployed and the webbing, reel, mounts and connector are suitable before fitting.
- Check F 13305707 / N 13250509 / TRW 34040558 against your original unit.
- Check front-left position and black webbing.
- Check the exact plug shape, locking tab and wire arrangement.
- Check the delivery address before payment. The seller cannot manually redirect an order after checkout.
Shipping and Collection
UK delivery: securely packed and sent using the service shown in the listing.
International delivery: available only to eligible destinations displayed by eBay at checkout. Customs, import charges, carrier restrictions and programme exclusions are controlled by eBay and the destination country.
Collection: may be available seven days a week until 8pm by appointment, including bank holidays by prior appointment. Arrange all collection details through eBay Messages and do not travel until the collection time is confirmed.
How to find us / WhatsApp
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Returns and Fitment Support
Returns are handled through the return terms displayed by eBay. Business sellers do not apply a blanket restocking fee. Where eBay policy permits, a deduction may be made only for actual loss in value when an item is returned used, altered, damaged, incomplete or in a different condition.
To avoid a wrong order, compare the part number and photographs before purchase. Fitment help is available through eBay Messages; provide the VIN and a clear image of the old belt label and connector.
VAT Information
Where this used part is sold under the Global Accounting VAT Margin Scheme, VAT is accounted for on the eligible margin and is not shown separately or reclaimable. The total price paid is the price shown at checkout.
25,000+ Parts in Stock
Large UK Used-Parts Inventory
More than 25,000 parts are held on the shelf at any one time, helping us identify, pick, protect and dispatch the correct component efficiently.
Illustrative stock image: Brayden Prato / Unsplash.
Fitting and Repair Support
Garage Services Subject to Availability
Fitting and wider vehicle repair work may be available by prior arrangement. Seat-belt and SRS work should be completed by a competent technician using the correct procedures and diagnostic equipment.
Illustrative garage image: Joseph Pillado / Unsplash.
Careful Packing and Dispatch
Protected for Transit
Used parts are identified, checked against the order and packed to help protect connectors, housings and mounting points during the permitted delivery journey.
Illustrative logistics image from Unsplash.
Support Reuse, Recycling and Small Business
🌍 Choosing a suitable used component helps keep serviceable parts in use, reduces demand for new raw materials and can prevent usable automotive components entering the waste stream.
♻️ Your purchase supports a local independent parts business while extending the useful life of an original vehicle component. Thank you for checking the fitment carefully and helping us send the correct part first time.