Fiat Grande Punto Punto Evo 2006-2018 RHD Accelerator Throttle Pedal 55702021

Fiat Grande Punto Punto Evo 2006-2018 RHD Accelerator Throttle Pedal 55702021

£16.87
Skip to product information
Fiat Grande Punto Punto Evo 2006-2018 RHD Accelerator Throttle Pedal 55702021

Fiat Grande Punto Punto Evo 2006-2018 RHD Accelerator Throttle Pedal 55702021

£16.87
THEPARTPILOT

Fiat Grande Punto / Punto Evo / Punto Accelerator Pedal Assembly

Visible part number: 55702021  |  Right-hand-drive application  |  Electronic throttle pedal

ACTUAL ITEM PHOTOS 30-DAY WARRANTY UK STOCK FITMENT CHECK AVAILABLE

Important Fitment Check Before Ordering

Do not order by registration year alone. Your original pedal must show 55702021, use the same rectangular electrical connector, and have the same mounting shape as the photographed item.

This is a used factory-fit electronic accelerator pedal assembly for selected right-hand-drive Fiat Type 199 vehicles. The part number is moulded into the sensor housing and is clearly shown in the close-up photograph below. Vehicle checkers and item specifics can contain incomplete or incorrect data, so the number, connector and mounting points take priority.

Actual Item Photographs

Fiat accelerator throttle pedal assembly 55702021 actual item
Actual accelerator pedal assembly supplied
Part number 55702021 moulded into accelerator pedal sensor housing
Close-up showing moulded part number 55702021
Fiat Punto electronic accelerator pedal side view
Side view: compare the arm, base and connector
Fiat Punto accelerator pedal profile and pedal pad
Profile view and pedal pad condition

The item supplied is the used part shown. Normal age-related cosmetic marks may be present. Check every photograph before purchase.

Where the Part Fits: Driver Footwell Location Guide

On a right-hand-drive vehicle, this assembly is installed in the driver's footwell at the far-right accelerator position. The electronic sensor housing and mounting base sit behind the pedal arm.

CLUTCH
BRAKE
ACCELERATOR
55702021
STATIC LOCATION DIAGRAM — RIGHT-HAND-DRIVE DRIVER FOOTWELL

This diagram identifies the installation area without using an unrelated third-party interior photo. Exact trim and pedal spacing vary by model and transmission.

Verified Vehicle Family and Model-Year Guide

Correction to the previous listing data: Punto Evo 2008 is not a valid model-year description. The Punto Evo was introduced in late 2009. The guide below separates Grande Punto, Punto Evo and the 2012-on Punto correctly.
Vehicle UK Model Period Body Fitment Requirements Status
Fiat Grande Punto
Type 199
2006 to late 2009 3-door or 5-door hatchback Right-hand drive; original pedal number 55702021; matching connector and mounting points Compatible when all identifiers match
Fiat Punto Evo
Type 199
Late 2009 to 2012 3-door or 5-door hatchback Right-hand drive; original pedal number 55702021; matching connector and mounting points Compatible when all identifiers match
Fiat Punto
2012 facelift, Type 199
2012 to 2018 3-door or 5-door hatchback Right-hand drive; original pedal number 55702021; matching connector and mounting points Compatible when all identifiers match

Engine note: this pedal family appears across petrol and diesel versions. Engine size alone is not a safe identifier. Match the original pedal number, plug and mounting arrangement.

Transmission note: many catalogue applications are manual-transmission vehicles. Automatic or Dualogic vehicles must be checked by the exact number and connector before ordering.

Vehicle Reference Photographs

2008 Fiat Grande Punto three door reference vehicle
Grande Punto 3-door reference vehicle
2012 Fiat Punto five door reference vehicle
2012-on Punto 5-door reference vehicle

Vehicle images are model-family references only, not the donor vehicle. Both photographs are public-domain/CC0 Wikimedia Commons images. Door count does not confirm fitment; the original part number and connector must still match.

Will Not Fit / Not Confirmed

  • Left-hand-drive vehicles where the pedal base, arm angle or mounting arrangement differs.
  • Any vehicle whose original pedal shows a different number, including closely related 55702xxx variants.
  • Vehicles with a different electrical plug, pin layout, pedal arm, base or mounting-hole pattern.
  • Automatic or Dualogic applications unless the original pedal is also 55702021 and is visually identical.
  • Older Punto Mk1/Mk2 or Type 188 vehicles unless the buyer proves an exact number, plug and mounting match.
  • Modified vehicles or vehicles with repaired, cut or altered pedal wiring.
Unsure? Send a clear photograph of the label/moulded number, connector and complete original pedal through eBay Messages before ordering.

Catalogue Cross-References

Visible Part Number55702021
Catalogue Cross-Reference50520961
Catalogue Cross-Reference52097728
Sensor Manufacturer MarkingBourns visible on housing
Vehicle LayoutRight-hand drive
Part TypeElectronic accelerator pedal

Replacement catalogues associate this part-number family with selected Alfa Romeo MiTo, Fiat 500L, Opel Corsa D and Vauxhall Corsa D applications. Those are catalogue cross-references only, not blanket confirmation that this exact used pedal fits every version. Different steering position, transmission, connector and mounting variants exist. For another vehicle, buy only after matching 55702021 and all photographs.

Where It Is Fitted and What It Controls

The assembly is fitted in the driver footwell on a right-hand-drive vehicle. It is mounted at the accelerator position and contains an electronic pedal-position sensor. When the driver presses the pedal, the sensor sends the requested pedal position to the engine control unit. The control unit then manages engine torque, fuelling and electronic throttle response.

Main ConstructionMoulded plastic sensor housing and pedal pad with metal pedal arm
Electrical FunctionIntegrated pedal-position signal
System TypeElectronic drive-by-wire throttle request

Common Fault Symptoms

  • Little or no response when the accelerator is pressed.
  • Intermittent, delayed or inconsistent throttle response.
  • Vehicle entering limp-home or reduced-power mode.
  • Engine-management warning light appearing.
  • Unusually high or unstable idle speed.
  • Pedal-position sensor fault codes or implausible signal readings.

Similar symptoms can also be caused by wiring, connector, power supply, earth, throttle-body or engine-control faults. Diagnostic testing is recommended before replacing any electronic component.

Why Choose a Factory-Fit Used Part?

A correctly matched factory-fit used component keeps the original mounting geometry, connector design and pedal feel intended for the vehicle. Very cheap copies may vary in sensor calibration, plug quality, pedal travel or housing strength. A used original-specification part can also cost substantially less than a new dealer-supplied assembly while keeping a serviceable component in use.

Important: the greatest benefit comes from ordering the correct number first time. Match 55702021 and the photographs rather than relying only on a vehicle registration lookup.

Fitting Guide

Estimated fitting time: approximately 20–45 minutes, plus diagnosis

Suggested Tools

  • Small ratchet, extension and suitable socket; commonly around 10 mm, but check the vehicle first.
  • Trim-removal tool if lower footwell trim obstructs access.
  • Torch, gloves and protective eyewear.
  • Diagnostic scan tool recommended for checking and clearing stored fault codes.

General Replacement Steps

1. Park safely, switch the ignition off, remove the key and follow the vehicle manufacturer's battery-disconnection procedure where required.
2. Move the driver's seat fully rearward and remove any lower trim that prevents safe access.
3. Photograph the original installation. Release the electrical connector by its locking tab; never pull the wires.
4. Remove the pedal mounting fasteners and withdraw the assembly without straining the wiring loom.
5. Compare both units side by side. Confirm 55702021, connector, pedal arm, base and every mounting point.
6. Install the replacement securely and tighten fasteners to the vehicle manufacturer's specified torque.
7. Reconnect the plug and any removed trim. Restore battery power if disconnected.
8. Check smooth pedal travel, start the vehicle, read/clear fault codes and confirm normal response before road use.
This is a safety-related driver-control input. Use a competent technician when uncertain. Never drive the vehicle if the pedal sticks, is loose or gives unpredictable engine response.

Static Garage Labour Estimate

Active calculators require JavaScript, which is not used in this listing. The table below gives a simple labour-only estimate using a typical 0.5-hour fitting allowance. Diagnosis, trim removal, seized fittings, coding or additional repairs may increase the total.

Garage Hourly Rate 0.5-Hour Labour Estimate
£50 per hour £25
£60 per hour £30
£70 per hour £35
£80 per hour £40
£90 per hour £45
£100 per hour £50
£120 per hour £60

Formula: estimated labour = garage hourly rate × 0.5. Fitting and repair services may be available subject to technician capacity; enquire through eBay Messages before purchase.

Stock, Collection and Dispatch

Reference image of automotive parts stored on warehouse shelves
Automotive parts stock reference image

25,000+ Parts in Stock

ThePartPilot carries more than 25,000 used automotive parts on the shelf at any one time.

Collection

Collection is available 7 days a week until 8 pm by prior appointment, including bank holidays by prior arrangement. Contact us only through the eBay contact options shown on the listing.

Protected Dispatch

Parts are checked, security-marked where applicable, carefully packed and dispatched from UK stock.

Warehouse reference image credit: Visitor7 / Wikimedia Commons, CC BY-SA 3.0. It illustrates parts storage and is not presented as a photograph of the seller's premises.

Delivery, Address and International Postage

  • We can dispatch only to the delivery address supplied at eBay checkout.
  • We cannot manually change the address after payment. If it is wrong, request cancellation and repurchase using the correct checkout address.
  • International delivery is offered through eBay's Global Shipping Programme for eligible items and destinations.
  • Destination availability, postage cost, delivery estimate and any import charges are calculated and displayed by eBay at checkout.

How to find us / WhatsApp

QR code to WhatsApp contact number 07495972152


Scan the QR code to open a WhatsApp chat for collections and enquiries.

If the QR image needs refreshing, generate it again from the same WhatsApp link.

VAT and Returns

VAT: where this item is sold under the second-hand goods global accounting margin scheme, VAT is not shown separately and is not reclaimable by the buyer.

Returns: returns are handled according to the return settings shown on the eBay listing and applicable eBay/consumer rights. The item must be returned complete, in the condition supplied, with security marks intact where used. Where eBay seller protections apply and an item is returned used, damaged, incomplete or in a materially different condition, eBay may permit a deduction of up to 50% to recover the proven loss in value. This is not an automatic restocking fee and does not apply simply because a buyer selects a particular return reason. Statutory rights and the eBay Money Back Guarantee are not restricted by this description.

To minimise incorrect orders, compare the original number, connector and complete pedal before purchase. Contact us through eBay Messages for a pre-purchase visual fitment check.

Supporting Reuse and a Small UK Business

♻️Reusing serviceable parts reduces demand for new manufacturing and keeps usable components out of waste streams. 📦Buying from a specialist used-parts business supports local jobs, testing, storage and careful dispatch. 🔧Accurate part-number matching helps prevent wasted journeys, unnecessary returns and avoidable packaging.

You may also like