Jaguar X-Type X400 2004-2009 Front Fog Lamp RH H11 4R8315200AA XR837532
Jaguar X-Type X400 2004–2009 Front Fog Lamp — Right — H11
Used round front fog lamp manufactured by Valeo and visibly labelled 4R83-15200-AA. The catalogue replacement/service number is XR837532. Suitable for either the right-hand front position on the verified vehicles and VIN ranges shown below.
⚠️ Read This Before Ordering
Do not order from model year, registration, engine size or visual similarity alone. Jaguar changed parts at specific VIN breakpoints. Match the number on your original lamp and send your full 17-character VIN through eBay Messages if you need confirmation.
The listing photographs confirm the supplied unit is marked 4R83-15200-AA. Photo comparison helps identify the housing, connector and mounting points, but a picture alone cannot prove vehicle compatibility.
Actual Item Photographs
The photographs below show the used lamp offered in this listing, including the front lens, rear housing and identification label.
THEPARTPILOT
THEPARTPILOT
THEPARTPILOT
Part Identification & Specification
| Component | Front fog lamp / lower bumper auxiliary lamp assembly |
|---|---|
| Manufacturer visible on housing | Valeo |
| Number visible on supplied lamp | 4R83-15200-AA 4R8315200AA |
| Catalogue replacement number | XR837532 |
| Valeo catalogue cross-reference | 088358 |
| Bulb type shown | H11 halogen, 12V 55W |
| Position | Front lower bumper; catalogue data identifies the unit as suitable for right-hand installation |
| Construction | Clear glass lens, moulded black housing, metal/plastic mounting structure and sealed electrical bulb connection |
| Condition | Used. Normal storage, road-use and handling marks should be expected. Inspect every actual-item photograph before purchase. |
| Bulb note | The bulb shown is a used consumable. Treat it as supplied for convenience only; replace it if its condition or output is uncertain. |
Verified Parts Compatibility
The table below is based on the 4R83-15200-AA → XR837532 catalogue supersession and published VIN breakpoints. A vehicle is not confirmed until its VIN and original lamp number match.
| Vehicle | Body style | Catalogue years | VIN / exclusion rule | Position |
|---|---|---|---|---|
| Jaguar X-Type X400 | 4-door Saloon and 5-door Estate | 2004–2009 | VIN E17541 to J39906 | Front left or front right |
| Jaguar S-Type X200 | 4-door Saloon | 2004–2008 | From VIN N13089; excludes R / performance model applications | Front left or front right |
| Jaguar XJ X350 | 4-door Saloon | 2008–2009 | From VIN H18680 | Front left or front right |
| Jaguar XK X150 | 2-door Coupe and Convertible | 2006–2015 | Excludes supercharged applications; verify VIN and original lamp number | Front left or front right |
Production year and first-registration year can differ. VIN and the number on the removed lamp take priority over the registration year. The seller cannot confirm a specific car without its complete VIN.
Known Non-Fitment / Do Not Order For
- Jaguar X-Type vehicles outside VIN range E17541–J39906.
- Jaguar S-Type vehicles before VIN N13089.
- Jaguar S-Type R / performance applications excluded by the parts catalogue.
- Jaguar XJ X350 vehicles before VIN H18680.
- Jaguar XK X150 supercharged applications excluded by the parts catalogue.
- Any vehicle whose original lamp carries a different service number, connector, mounting pattern or lens design.
- Any non-listed vehicle merely because the lamp looks similar. No additional cross-make fitment is claimed.
Reference Vehicle & Lamp Location
This lamp is mounted in the lower outer front bumper aperture. It produces a low, wide beam intended to improve near-road visibility in poor weather. The vehicle lighting switch requests fog-lamp operation and the vehicle wiring, fuse/relay and control system supply the lamp.
REFERENCE
REFERENCE
Vehicle image attribution: Rudolf Stricker, Wikimedia Commons. First image licensed CC BY-SA 3.0 / GFDL; second image released for use with attribution. Images are shown for model and location reference only.
Symptoms of a Faulty or Damaged Fog Lamp
- Lamp remains inoperative after checking the H11 bulb, fuse and power supply.
- Intermittent operation caused by a worn connector, corrosion or internal moisture.
- Cracked, heavily chipped, cloudy or damaged lens reducing light output.
- Condensation or water entry caused by a failed seal or damaged housing.
- Broken mounting tabs causing vibration, poor alignment or an insecure bumper fit.
- Uneven beam pattern or one side appearing noticeably dimmer than the other.
- A defective or insecure lamp may affect roadworthiness or inspection results, depending on the vehicle and applicable test requirements.
Why Choose a Factory-Fit Used Component?
Correct physical integration
Factory-fit Jaguar/Valeo components are designed around the intended bumper aperture, mounting tabs, electrical connector, lens geometry and beam pattern.
Known identification
The visible engineering number can be matched to the removed component and checked against the VIN, reducing the risk of ordering a visually similar but incompatible copy.
Lower environmental impact
Reusing a serviceable original component extends its working life and reduces demand for new raw materials, energy-intensive manufacturing and avoidable waste.
Potential cost saving
A quality used component can cost substantially less than a new dealer-supplied replacement. Savings vary by part, condition, availability and current new-part pricing.
Fitting Guide
Access differs by bumper version and vehicle model. Some cars allow access through the lower splash shield or wheel-arch liner; others may require the bumper corner or front bumper to be loosened. Use the correct workshop procedure for the VIN.
- Park on level ground, apply the parking brake, switch off the ignition and exterior lights, and allow the lamp to cool.
- If lifting the vehicle, use the specified jacking points and support it securely on rated axle stands. Never work under a vehicle supported only by a jack.
- Remove the relevant lower splash shield, wheel-arch liner fasteners or bumper access panel as required by the model.
- Inspect the connector and wiring for heat damage, moisture or corrosion before replacing the lamp.
- Disconnect the H11 electrical plug without pulling on the wiring.
- Remove the lamp retaining screws/clips while supporting the lamp and noting the original mounting orientation.
- Compare the old and replacement units side by side: number, connector, housing, lens, mounting tabs and left/right mounting position.
- Install the replacement without forcing the mounts. Refit all original fasteners and panels securely.
- Reconnect the electrical plug, test operation and check that the beam is secure and correctly aligned.
- After the first wet-weather use, inspect for condensation or water entry around the lens and rear seal.
Important: Do not touch the glass of a replacement halogen bulb with bare fingers. Incorrect lifting, bumper removal or wiring repair can cause injury or damage. Use a competent technician where needed.
Tools, Estimated Time & Labour Cost
| Likely tools | Trim-clip removal tool, Torx-bit set, 8 mm and 10 mm sockets, ratchet and extension, screwdriver set, gloves, inspection lamp, vehicle jack and rated axle stands where required. |
|---|---|
| Estimated workshop time | 0.5–1.5 hours, depending on model, access method, seized fasteners, previous repairs and whether bumper loosening is required. |
| Cost formula | Garage hourly rate × booked labour time = estimated labour charge. Parts, diagnostics, consumables and taxes charged by the garage are additional. |
Static Labour Cost Calculator
| Garage rate | 0.5 hour | 0.75 hour | 1.0 hour | 1.5 hours |
|---|---|---|---|---|
| £50 per hour | £25.00 | £37.50 | £50.00 | £75.00 |
| £75 per hour | £37.50 | £56.25 | £75.00 | £112.50 |
| £100 per hour | £50.00 | £75.00 | £100.00 | £150.00 |
| £125 per hour | £62.50 | £93.75 | £125.00 | £187.50 |
🔧 Fitting Service
A fitting and repair service may be available subject to workshop capacity, vehicle condition and prior agreement. Contact us through eBay Messages before purchase or travel. No appointment is confirmed until agreed in writing.
Workshop & Parts Operation
THEPARTPILOT
THEPARTPILOT
Workshop images: Shixart1985 / Wikimedia Commons, CC BY 2.0. Images are illustrative and do not represent the exact ThePartPilot premises.
Delivery, International Shipping & Address Accuracy
Check the delivery address before completing checkout. We dispatch only to the address supplied by eBay at checkout and cannot manually redirect or replace it after payment. If the address is wrong, request cancellation before dispatch and reorder using the correct address.
UK delivery and eligible international delivery are provided through the options shown by eBay. International availability depends on item eligibility, destination restrictions and the buyer's checkout page.
eBay Global Shipping Programme destinations currently listed by eBay
European destinations: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain and Sweden.
Other listed destinations: Antigua and Barbuda, Aruba, Australia, Bahamas, Bahrain, Bangladesh, Barbados, Belize, Bermuda, Bolivia, Brazil, Brunei Darussalam, Cambodia, Canada, Cayman Islands, Chile, China, Colombia, Costa Rica, Dominica, Dominican Republic, Ecuador, Egypt, El Salvador, French Guiana, Grenada, Guadeloupe, Guatemala, Guernsey, Honduras, Hong Kong, Iceland, Indonesia, Israel, Jamaica, Japan, Jersey, Jordan, Kuwait, Liechtenstein, Macau, Malaysia, Maldives, Martinique, Mexico, Monaco, Montserrat, New Zealand, Nicaragua, Norway, Oman, Pakistan, Panama, Paraguay, Peru, Philippines, Qatar, Reunion, Saint Kitts and Nevis, Saint Lucia, Saudi Arabia, Singapore, South Africa, South Korea, Sri Lanka, Switzerland, Taiwan, Thailand, Trinidad and Tobago, Turks and Caicos Islands, United Arab Emirates, Ukraine, Uruguay, United States of America and Vietnam.
Destination coverage can change and some parts may be restricted by eBay, carrier, customs or local import rules. The destination and price displayed at checkout are decisive.
How to find us / WhatsApp
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Returns, Fitment Evidence & Order Protection
- Use the compatibility table, VIN breakpoint and part number before ordering.
- Keep clear photographs of your old component, its label and connector until the repair is complete.
- Do not modify, paint, open, wire-cut or force-fit the supplied part while checking compatibility.
- Returns are handled under the return terms shown in the eBay listing and applicable consumer law.
- Where eBay and the law permit a deduction for loss in value, it may apply only when an item is returned used, damaged, incomplete or materially altered — not automatically because the buyer selected a particular return reason.
- If the supplied item materially differs from the listing description or actual-item photographs, contact us through eBay Messages.
VAT Information
Supplied under the applicable second-hand goods margin / global accounting arrangements. VAT is not shown separately and is not reclaimable as input tax. The checkout total is the amount payable for the item, excluding any separate delivery or import charges shown by eBay.
25,000+ Parts Ready for Dispatch
ThePartPilot holds more than 25,000 vehicle parts on the shelf at any one time. Parts are identified, stored and prepared for secure dispatch so customers can obtain the correct component with clear evidence.
THEPARTPILOT
Warehouse image: Shixart1985 / Wikimedia Commons, CC BY 2.0. Illustrative image; not a photograph of the exact ThePartPilot warehouse.
Support a Local Small Business ♻️
By purchasing a reusable vehicle component, you support a local independent parts business while helping keep serviceable parts in circulation. Reuse can reduce premature scrappage, packaging waste, raw-material demand and the energy associated with manufacturing a replacement from new.
🚗 Correct part first time • 🔧 Practical repair support • 📦 Careful dispatch • 🌍 More responsible reuse