Windscreen Washer Pump
12V • 2 Pin • Single Outlet
This listing is built around the actual component markings, connector shape and outlet configuration shown below. Match all three before ordering.
Actual Item Reference Photos
THEPARTPILOT
THEPARTPILOT
THEPARTPILOT
THEPARTPILOT
Item Details & Engineering References
| Specification | Verified detail |
|---|---|
| Part type | Electric windscreen washer-fluid pump |
| Voltage / connector | 12V system; rectangular 2-pin connection |
| Fluid outlets | One outlet / mono pump |
| Primary part number | 286203634R |
| Confirmed one-outlet cross references | 289200001R and 8200067015, subject to an exact visual and connector match |
| Do not confuse with | 286200851R, 8200295685 or 289200004R. These are shown on the moulded reference chart as two-outlet variants, not confirmation for this one-outlet pump. |
| Material / finish | Black moulded engineering-plastic housing with integrated electric motor and push-fit reservoir neck |
| Mounting position | Push-fitted into the lower section of the washer-fluid reservoir using a sealing grommet |
| Included | The washer pump shown in the actual photographs only. Reuse or replace the sealing grommet and hoses as required. |
| Condition | Pre-owned vehicle component. Expect normal cosmetic storage and removal marks; inspect every photograph. |
Compatibility & Non-Fitment Table
Model-year lists alone are not safe for this component. Washer systems vary by body style, rear-wash equipment, trim, production date and connector. The exact part number and physical layout take priority.
| Vehicle / application | Status | What must match |
|---|---|---|
| Renault, Dacia or Nissan application specifying 286203634R, 289200001R or 8200067015 | PART-NUMBER MATCH | One fluid outlet, rectangular 2-pin plug, matching reservoir neck and hose direction |
| Peugeot 208 standard hatchback, 2012–2019 | NOT CONFIRMED | Many catalogue applications use a dual-outlet pump instead. Do not order unless your removed unit and number match exactly. |
| Peugeot 208 Van / Furgon | VIN / OLD-PART CHECK REQUIRED | At least one market listing links this number to a 2013 van, but that is insufficient to guarantee all vans, engines or production dates. |
| Vehicles requiring front and rear wash from a reversible dual-outlet pump | WILL NOT FIT | This item has one outlet. Do not substitute it for a two-outlet unit. |
| Round plug, 3-pin plug, different outlet angle, different neck diameter or different moulded number | WILL NOT FIT | The electrical and fluid connections must be identical. |
Vehicle Shape Reference — Not Fitment Proof
THEPARTPILOT • REFERENCE
The pump normally clips into the washer bottle low behind the front bumper or inner wheel-arch liner. Exact side and access route vary by vehicle.
LOW IN WASHER BOTTLECHECK FOR LEAKSWhat This Part Does
Function
When the wash switch is operated, the pump draws screenwash from the reservoir and sends it through the hose to the washer jets. Correct pressure is needed to clear dirt and maintain safe forward visibility.
Common Fault Symptoms
- No washer spray and no pump sound
- Weak, delayed or intermittent spray
- Fluid leaking around the pump or reservoir seal
- Pump runs but fluid does not reach the jets
- Repeated fuse failure caused by a seized or shorted pump
Why Match the Manufacturer-Marked Part
Correct Geometry
A matching factory-specified component is more likely to have the correct reservoir neck, sealing depth, plug shape, outlet angle and electrical load.
Avoid Cheap-Copy Problems
Low-cost copies may differ in connector tension, outlet alignment, pump pressure or sealing quality. A carefully matched pre-owned manufacturer-marked part can offer strong value compared with buying new, while keeping a serviceable component in use.
Fitting Guide
Typical Tools
- Trim-clip removal tool
- Torx and socket set
- Small pliers and flat screwdriver
- Drain tray and clean washer fluid
- Gloves and eye protection
- Jack and axle stands if wheel-arch access is required
Estimated Repair Time
Typical: 0.5–1.0 hour.
Restricted access: 1.0–1.5 hours where a wheel, liner or bumper section must be removed.
Times are guidance only. Corroded fixings, seized clips and model-specific access can increase labour.
- Park on level ground, switch the ignition off, remove the key and allow the vehicle electronics to power down.
- Drain or siphon enough washer fluid to prevent spillage. Raise and support the vehicle safely only where necessary.
- Remove the appropriate wheel-arch liner fasteners or access panel. Keep clips organised for refitting.
- Identify the pump in the lower washer bottle. Photograph the hose route and connector before removal.
- Disconnect the 2-pin plug and washer hose. Catch remaining fluid in a tray.
- Pull the pump straight from the reservoir grommet. Inspect the seal for hardening, splitting or distortion.
- Lightly wet the seal with clean washer fluid, press the replacement pump fully into place, then reconnect hose and plug.
- Refill, operate the washers and inspect carefully for leaks and correct spray pressure.
- Refit all liners, clips and the wheel where removed. Tighten wheel bolts to the vehicle manufacturer’s specified torque.
Static Garage Labour Estimate
Active calculators and JavaScript are not used in this eBay description. Use the table below: hourly rate × labour time = estimated labour charge.
| Garage rate | 0.5 hour | 1.0 hour | 1.5 hours |
|---|---|---|---|
| £50/hour | £25 | £50 | £75 |
| £70/hour | £35 | £70 | £105 |
| £90/hour | £45 | £90 | £135 |
| £110/hour | £55 | £110 | £165 |
Labour only. Fluids, seals, clips, diagnostic time, wheel alignment and additional repairs are not included.
Fitting Service
A fitting service may be available subject to vehicle, location, workshop capacity and prior arrangement. Ask through eBay Messages before purchase. Do not travel without a confirmed appointment.
Delivery, Address, VAT & Returns
Dispatch & Delivery
- Worldwide delivery is offered where eBay’s international shipping programme is available for the item and destination.
- Eligible countries, cost, import charges and estimated delivery are shown by eBay at checkout.
- Please check your checkout address before payment. We cannot redirect or manually change the address after the order is placed.
VAT & Returns
- Sold under the VAT margin/global accounting scheme where applicable; VAT is not separately stated or recoverable.
- Returns are handled under the return terms shown on the eBay listing.
- Return the complete item in the same condition and packaging. Any deduction permitted by eBay must reflect actual loss in value from use, damage, missing parts or inadequate packaging; there is no automatic restocking charge.
From Our Shelf to Your Door
Large on-shelf vehicle-parts inventory
Fitment assistance and repairs subject to availability
Parts securely packed for the journey
Support a Local Parts Business ♻️
Buying a serviceable pre-owned component supports a local independent business and helps keep useful vehicle parts in circulation instead of being discarded prematurely. Reuse can reduce demand for newly manufactured replacements, while careful part-number checking helps prevent wasted journeys, unnecessary returns and avoidable packaging. Thank you for choosing ThePartPilot. 🚗🔧🌍
1) Match 286203634R / 289200001R / 8200067015.
2) Confirm one hose outlet.
3) Confirm rectangular 2-pin plug.
4) Compare the neck, outlet angle and housing with every photo.
5) Ask through eBay Messages before ordering if anything differs.