Suzuki Alto 2009-2015 5Dr Passenger Rear Left Outer Door Handle 82802M68K50-5PK
Suzuki Alto 2009-2015 5Dr Passenger Rear Left Outer Door Handle 82802M68K50-5PK
|
✓ 30 DAY Seller Warranty |
25,000+ Parts In Stock |
✓ FITMENT Verification Available |
Passenger Rear Left
Exterior Door Handle
Black textured rear left outer door handle for the Suzuki Alto 5-door UK model, 2009–2015. UK position is Nearside Rear / NSR / Passenger Rear.
“Left” means the vehicle's left side when sitting in the car facing forwards. On a UK right-hand-drive Alto this is normally called the passenger side / nearside. This listing is specifically for the rear left door position.
ACTUAL ITEM — CHECK THESE PHOTOS FIRST
These are photographs from this listing. Please compare the visible shape, mounting points and linkage clip with your existing handle.
|
|
SUZUKI ALTO 5-DOOR BODY
The two photographs below show the correct Alto GF-generation 5-door body family. They are reference photographs only — not the donor vehicle and not the vehicle from which the supplied part was removed.
VEHICLE COMPATIBILITY & FITMENT CHART
| Vehicle | Years | Body | Position | Reference | Fitment |
|---|---|---|---|---|---|
| Suzuki Alto | 2009–2015 | 5-door hatchback / GF body family | Rear Left / NSR / UK Passenger Rear | 82802M68K50-5PK | Main confirmed application |
| Nissan Pixo | 2009–2013 | UA0 5-door hatchback | Rear Left when rear geometry matches |
82802M68K50-5PK Cross-reference 80607-4A03D |
Cross-fit — visually compare before purchase |
Some parts catalogues use the same left-hand handle reference for more than one left-side door application. The physical item in this listing is specifically identified from the donor as REAR LEFT / NSR. A Nissan Pixo buyer should therefore compare the rear handle's mounting studs, linkage arrangement and blue retaining clip with the photographs above before fitting.
|
✓ DESIGNED TO FIT
✓ Suzuki Alto UK 5-door 2009–2015
✓ Rear left exterior door position ✓ UK nearside / passenger rear / NSR ✓ Black textured handle style shown ✓ Two-stud rear mounting arrangement shown ✓ Matching blue linkage-clip arrangement ✓ Nissan Pixo 2009–2013 only where the rear geometry/reference matches |
✕ DO NOT ASSUME IT FITS
✕ Driver/right-hand side door
✕ Front door without confirming the physical rear application ✕ Earlier/different Alto generations ✕ A different global Alto body simply because it says “Alto” ✕ A handle with different studs or linkage clip ✕ A key-barrel-equipped design if your original differs ✕ Any vehicle where the photographed rear geometry does not match |
Send your registration/VIN information and clear photographs of your existing handle through eBay Messages before ordering.
20-SECOND IMAGE-FIRST FITMENT CHECK
2. Does your existing handle have the same black textured face?
3. Does its rear side use the same two threaded studs?
4. Does the linkage arrangement and blue retaining clip correspond?
5. Is your car the correct 5-door Alto body, or verified Pixo application?
6. Does your removed-part reference or parts record agree with 82802M68K50-5PK / applicable cross-reference?
If any answer is “no” or “not sure”, please do not install the part until fitment has been checked.
ITEM DETAILS & SPECIFICATIONS
| Vehicle Brand | Suzuki |
| Part Type | Exterior / Outer Side Door Handle |
| Placement | Rear Left — UK Nearside Rear / Passenger Rear / NSR |
| Manufacturer Part Number | 82802M68K50-5PK |
| Base Reference | 82802M68K50 |
| Interchange Part Number | Nissan 80607-4A03D — cross-reference; compare application |
| Superseded Part Number | No confirmed superseded number verified |
| Colour | Black |
| Finish | Textured exterior finish |
| Construction | Moulded plastic handle body, metal threaded mounting studs and plastic linkage retaining component |
| Body Style | 5-door hatchback application |
| Donor / Colour Marking | White handwritten marking visible: “NSR ALTO 2013” |
| Engine / Gearbox | Door/body configuration and handle geometry determine fitment; engine and gearbox are not the deciding factors for this component |
| Condition | Pre-owned recycled vehicle component. Expect normal age/storage marks consistent with the photographs |
| Included | Handle assembly shown in the listing photographs. No additional items should be assumed unless pictured |
| Seller Warranty | 30 Days |
| eBay Item Number | 147479020730 |
WHERE IS THIS PART FITTED & WHAT DOES IT DO?
This handle mounts to the outside of the vehicle's rear left door. On a UK Alto this is normally the passenger-side rear door.
Pulling the exterior handle moves the door-release linkage connected to the latch mechanism. When the vehicle is unlocked and the latch/linkage is functioning correctly, this movement releases the rear-door latch so the door can be opened from outside.
COMMON SIGNS THE OUTER HANDLE MAY NEED REPLACEMENT
✓ Handle feels loose or has excessive free movement
✓ Cracked or broken outer grip/body
✓ Handle sticks and does not return smoothly after being pulled
✓ Linkage retaining clip is damaged or has detached
✓ Door opens from the interior handle but not correctly from outside
✓ Physical damage following impact or attempted forced entry
✓ Cosmetic deterioration severe enough to justify replacement
WHY CHOOSE A FACTORY-FIT ORIGINAL VEHICLE PART?
A serviceable original vehicle component was designed around the vehicle's existing mounting points, door profile and linkage arrangement. This can be a significant advantage over a low-cost pattern component where moulding dimensions, texture, lever travel, clips or mounting alignment may differ.
|
✓ Mounting alignment Designed around the original door architecture. |
✓ Correct profile Helps retain the intended exterior shape and feel. |
|
✓ Linkage compatibility Reduces the risk of incorrect lever or clip geometry. |
✓ Better value A recycled original component can cost substantially less than the equivalent new replacement. |
Savings vary by component, condition, availability and current new-part pricing; no fixed percentage saving is promised by this listing.
FITTING GUIDE
The guide below is a practical overview rather than a vehicle-manufacturer workshop procedure. Fastener positions can vary with trim level and previous repairs.
Raise the window fully, switch the ignition off, remove the key and work with the rear door open wherever possible.
STEP 2 — Protect the trim and paint
Use masking tape or suitable protection around vulnerable painted/trim edges.
STEP 3 — Remove the interior rear-door trim panel
Remove the applicable screws and trim clips using a proper trim-removal tool. Disconnect any electrical connector only where fitted.
STEP 4 — Access the rear of the handle
Carefully peel back the moisture barrier far enough to reach the exterior-handle mounting area. Do not tear it unnecessarily.
STEP 5 — Photograph the linkage first
Take a clear photograph before disconnecting anything. Release the plastic retaining clip and linkage/rod from the old handle without forcing brittle plastic components.
STEP 6 — Remove the mounting hardware
Use the correct small metric socket for the nuts fitted to your vehicle's two handle studs. The exact socket size should be confirmed on the car rather than guessed.
STEP 7 — Remove and compare
Withdraw the existing handle from outside the door. Put it next to the replacement and compare the face profile, two studs, linkage lever and retaining clip arrangement.
STEP 8 — Install the replacement
Position the replacement handle correctly and tighten its retainers evenly. Avoid excessive force on the plastic housing.
STEP 9 — Reconnect the linkage
Refit the rod/linkage in exactly the same orientation and lock the retaining clip securely.
STEP 10 — TEST BEFORE CLOSING THE DOOR
With the door still open, operate lock/unlock and the exterior handle several times. Confirm that the latch releases and resets correctly before closing the door.
STEP 11 — Reassemble
Reseal the moisture barrier properly and reinstall the interior trim panel and clips.
Do not close the door for the first test until you have confirmed that the latch releases correctly. Incorrect linkage assembly can leave a door difficult to reopen. If you are not comfortable carrying out the work, use a competent repair technician.
RECOMMENDED TOOLS
| Trim-removal tools | For releasing the rear door card with less risk of damage |
| Phillips / Pozidriv screwdriver as fitted | Interior trim fasteners |
| Small metric socket set & ratchet | Exterior-handle retaining hardware |
| Short extension | Improves access inside the door shell |
| Small flat screwdriver / pick | Linkage retaining clip |
| Panel-clip pliers | Optional but useful for stubborn trim clips |
| Masking tape, torch & gloves | Protection, visibility and safe handling |
REPAIR TIME & LABOUR COST ESTIMATOR
Planning estimate for a straightforward handle replacement: approximately 0.5 to 1.0 labour hour. This is an estimate for budgeting, not an official workshop book time.
Calculation: garage hourly rate × estimated repair time. Static table is used so this eBay description contains no JavaScript or active calculator.
| Garage Rate | 0.5 Hour Estimate | 1.0 Hour Estimate |
|---|---|---|
| £40/hour | £20 | £40 |
| £50/hour | £25 | £50 |
| £60/hour | £30 | £60 |
| £70/hour | £35 | £70 |
| £80/hour | £40 | £80 |
| £90/hour | £45 | £90 |
| £100/hour | £50 | £100 |
| £120/hour | £60 | £120 |
Labour examples exclude diagnosis, damaged trim clips, seized fixings, additional door/latch faults, parts and consumables. Actual workshop rates and repair times vary.
FITTING SERVICE AVAILABLE
We can also offer a fitting/repair service for selected parts subject to technician, workshop and appointment availability. Please ask through eBay Messages before making travel arrangements.
|
|
THEPARTPILOT carries a large working stock of recycled vehicle components, helping customers source replacement parts without automatically resorting to a brand-new component.
DELIVERY & CHECKOUT ADDRESS
Orders are dispatched using the delivery address shown on the completed eBay order. Please make sure your house number, street, postcode and recipient details are correct before payment. We cannot simply redirect an eBay order to a different address after checkout.
International delivery: available services, destinations, charges, duties and taxes depend on the destination, item category and the options actually presented by eBay at checkout. Please rely on the delivery options displayed on the live eBay order rather than assuming that every destination or international programme is available for this item.
No separate postage promise is made inside this description; the live eBay postage section and checkout are the controlling source for current service and cost.
VAT / GLOBAL ACCOUNTING
Where this recycled component is sold under our applicable VAT margin / Global Accounting treatment, VAT is not separately itemised on the sale. There is therefore no separate reclaimable VAT amount shown on the invoice for this item.
RETURNS & FITMENT RESPONSIBILITY
We provide the photographs, donor marking, reference numbers, position information and compatibility guidance above specifically to help buyers order the correct component first time.
Returns are handled in accordance with the return terms displayed on the eBay listing and applicable eBay policy. A returned component should be kept in the same condition wherever reasonably possible and should not be forced, modified, painted, cut or damaged merely to test whether it fits.
Where eBay permits a seller to make a refund deduction because a returned item has suffered an actual loss in value, any such adjustment must relate to that loss in value. There is no automatic fixed restocking deduction simply because a fitment return is opened.
REUSE A SERVICEABLE PART • SUPPORT A LOCAL BUSINESS
Choosing a serviceable recycled vehicle component helps extend the useful life of an existing part rather than automatically replacing it with a newly manufactured item. Reuse can also reduce demand for additional manufacturing and packaging while helping keep repairable vehicles on the road.
Thank you for supporting an independent local parts business. 💙
STOCK • PICK • PACK • DISPATCH 📦
FINAL CHECK BEFORE YOU ORDER
Vehicle: Suzuki Alto 5-door 2009–2015?Required Door: Rear Left?
UK Position: Nearside / Passenger Rear / NSR?
Handle: Black textured exterior type?
Rear Mounting: Same two studs?
Linkage: Same blue retaining-clip arrangement?
Reference: 82802M68K50-5PK where applicable?
If everything matches, this is the application this listing has been prepared for. If anything differs, contact us through eBay before fitting.
WhatsApp QR for Fitment Help / Appointment Enquiries
Scan the QR code to contact ThePartPilot on WhatsApp for fitment checks, appointments or fitting service availability.For faster fitment help, send your vehicle registration, VIN if available, and clear photos of your existing part, connector and part number.