Vauxhall Agila B 2008-2014 Accelerator Throttle Pedal 49400-51K01 6PV009074-04
Vauxhall Agila B 2008-2014 Accelerator Throttle Pedal 49400-51K01 6PV009074-04
Vauxhall Agila B Accelerator Pedal Assembly
Electronic accelerator pedal with integrated position sensor. The exact photographed label is the controlling reference for this listing.
Actual item photographs
These are the listing photographs of the part supplied. Compare every visible feature with the unit removed from your vehicle before ordering.
Part identification
Verified from the photographs
What is supplied
- Electronic accelerator pedal assembly shown in the actual photographs
- Integrated pedal position sensor and connector housing
- Moulded pedal arm, tread and mounting body
- No bracket, nuts, wiring loom, trim or diagnostic equipment unless visibly shown
- Used condition with normal cosmetic marks and identification writing visible
Correct vehicle style — 5-door Vauxhall Agila B
The vehicle below is a 2009 Vauxhall Agila Design 1.2, shown only as a body-shape reference. It is the correct five-door Agila B generation. Vehicle colour and trim level do not determine pedal fitment.
Vehicle reference photographs: Harvey Bold, CC BY 4.0, Wikimedia Commons. The vehicle shown is not included.
Where the part is fitted and what it controls
Right-hand-drive driver footwell
manual only
RIGHT-MOST PEDAL
Location diagram, not a photograph. Automatic vehicles omit the clutch pedal. The accelerator remains the right-most pedal.
The assembly mounts inside the driver footwell at the right side of the pedal box/bulkhead area. Its sensor converts pedal travel into an electrical signal sent to the engine control unit.
- Reports how far and how quickly the driver presses the accelerator
- Allows the control unit to command throttle opening on petrol engines
- Allows the control unit to calculate injection demand on diesel engines
- Works as a safety-related driver-demand input; incorrect signals can trigger reduced-power operation
Primary compatibility — current listing application
The compatibility data attached to this listing identifies the following Vauxhall Agila Mk II (B), chassis H08, five-door hatchback applications for model years 2008–2014. Fitment is still conditional on an exact part-label, connector, mounting-point and VIN match.
| Status | Make / Model | Body / Chassis | Years | Engine | Engine code | Power | Required check |
|---|---|---|---|---|---|---|---|
| Primary application | Vauxhall Agila B / Mk II | 5-door hatchback, H08 | 2008–2014 | 1.0 12V petrol, 996cc | K10B | 48kW / 65hp | 49400-51K01 + 6-pin photo match + VIN |
| Primary application | Vauxhall Agila B / Mk II | 5-door hatchback, H08 | 2008–2014 | 1.2 i 16V petrol, 1242cc | K12B | 63kW / 86hp | 49400-51K01 + 6-pin photo match + VIN |
| Primary application | Vauxhall Agila B / Mk II | 5-door hatchback, H08 | 2008–2014 | 1.2 i 16V petrol, 1242cc | K12B | 69kW / 94hp | 49400-51K01 + 6-pin photo match + VIN |
| Primary application | Vauxhall Agila B / Mk II | 5-door hatchback, H08 | 2008–2014 | 1.3 CDTi diesel, 1248cc | D13A / Z13DTJ | 55kW / 75hp | 49400-51K01 + 6-pin photo match + VIN |
Additional number-match applications — confirmation required
Public part-number records also associate 49400-51K01 with selected Suzuki Splash five-door models. This is not presented as automatic interchangeability. Do not order for a Splash unless the VIN and the removed pedal label, connector key, six terminals, three mounting points and arm geometry all match.
| Status | Vehicle | Years found with this number | Engine evidence | Order rule |
|---|---|---|---|---|
| Conditional | Suzuki Splash, 5-door hatchback | 2012–2015 | 1.0 petrol, K10B | VIN + exact 49400-51K01 label + full photo match required |
| Conditional | Suzuki Splash, 5-door hatchback | 2012–2014 | 1.2 petrol, K12B | VIN + exact 49400-51K01 label + full photo match required |
No other vehicle is claimed as a confirmed application in this description. Similar-looking pedals used on other Suzuki or Vauxhall models may carry a different suffix and must not be treated as interchangeable.
Will not fit / do not assume fitment
Not suitable without further proof
- Vauxhall Agila A / Mk I, approximately 2000–2007
- Any pedal labelled 49400-51K00, 49400-51K50, 49400-51K51 or another suffix
- Pedals with a different connector key, terminal count or pin layout
- Pedals with different mounting-point spacing or arm geometry
- Vehicles where the removed part number cannot be read or verified
- Universal applications — this is not a universal pedal
Five-point pre-purchase check
- Send the full 17-character VIN through eBay Messages
- Photograph the full removed pedal from the same angles as this listing
- Confirm printed number 49400-51K01 character for character
- Confirm six terminals, connector shell shape and locking key
- Confirm all mounting points and pedal-arm shape before payment
Common symptoms and correct diagnosis
Symptoms that may be associated with the pedal sensor
- Engine warning light illuminated
- No response when the accelerator is pressed
- Intermittent or restricted accelerator response
- Increased idle speed
- Reduced-power or limp-home mode
- Pedal-position or correlation fault codes stored in the control unit
Do not replace by symptom alone
The same symptoms can be caused by damaged wiring, poor connector contact, missing power or ground, water ingress, control-unit faults, throttle-body faults or other engine-management issues.
Recommended checks: read diagnostic trouble codes, inspect the wiring and connector, verify supply/ground, examine live data for both pedal tracks and compare the signal sweep against workshop information.
Construction, condition and value
Materials
Moulded engineering-plastic pedal arm and electronic housing, textured pedal tread, internal sensor electronics and metal mounting inserts. The exact polymer grade is not confirmed.
Used condition
Previously fitted component. Expect normal marks consistent with removal, storage and prior use. Identification writing and cosmetic wear are visible in the actual photographs.
Better matching
A used factory-specification component with the exact same number, connector and geometry can provide a more dependable match than a low-cost pattern copy selected only by model name.
Fitting instructions
Required tools
- Good work light or torch
- Metric socket set, ratchet and suitable extension
- Small trim tool if a lower panel obstructs access
- Torque wrench covering the specified workshop torque
- Diagnostic scan tool for fault codes and live data
- Multimeter or oscilloscope for qualified electrical diagnosis
Estimated time
0.3–0.6 hr
Approx. 18–36 minutes for a straightforward physical replacement with clear access. Diagnosis, seized fasteners, trim removal, wiring repairs or post-fit testing may add 0.5–1.0 hour or more.
Estimate only, not a manufacturer labour time. Vehicle condition and workshop procedure vary.
- Make the vehicle safe. Park on level ground, select neutral/park, apply the parking brake, switch off the ignition and remove the key. Allow control units to power down.
- Follow the workshop electrical procedure. Check the vehicle repair manual before disconnecting the battery. Preserve radio codes and memory settings where applicable. Never connect or disconnect the pedal with the ignition switched on.
- Gain access. Move the driver seat fully rearward, remove the floor mat and remove only the lower trim specified by the workshop manual.
- Disconnect the plug. Release the connector lock and pull on the connector body, never the wires. Inspect for corrosion, heat damage, spread terminals or broken locking tabs.
- Remove the assembly. Support the pedal and remove the three accelerator-pedal flange nuts. Keep fixings safe unless replacement hardware is specified.
- Compare before fitting. Match 49400-51K01, 6PV 009 074-04, six terminals, connector key, three mounting locations and pedal-arm shape. Stop if anything differs.
- Install correctly. Position the replacement without forcing it. Start all nuts by hand and tighten evenly to the torque stated in the vehicle workshop information. No torque figure is guessed here.
- Verify operation. Reconnect as specified, clear stored codes only after recording them, check both pedal-position tracks in live data, confirm smooth return and make sure no warning lamps remain.
- Final safety check. Carry out a controlled stationary check and a safe road test by a competent person. Stop immediately if pedal response is abnormal.
Static garage labour estimator
No scripts or active calculator are used. Multiply the garage hourly rate by the booked labour time. Parts, VAT, diagnostics, consumables and minimum booking charges may be additional.
| Garage rate | 0.3 hour | 0.5 hour | 0.6 hour | 1.0 hour with diagnosis |
|---|---|---|---|---|
| £40 per hour | £12 | £20 | £24 | £40 |
| £60 per hour | £18 | £30 | £36 | £60 |
| £80 per hour | £24 | £40 | £48 | £80 |
| £100 per hour | £30 | £50 | £60 | £100 |
| £120 per hour | £36 | £60 | £72 | £120 |
Fitting and repairs
Fitting and repair services may be available subject to workshop capacity, vehicle condition and prior approval. Arrange through eBay Messages before travelling or purchasing a fitting slot.
Collections
Collection may be arranged seven days a week up to 8pm, including bank holidays, strictly by prior appointment and confirmation through eBay Messages.
Large UK stockholding and workshop support
ThePartPilot carries more than 25,000 vehicle parts on the shelf at any one time, with collection and fitting options subject to availability.
The three photographs above are illustrative licensed stock images and are not representations of the seller’s exact premises.
UK and international delivery
International delivery is offered on eligible orders through eBay’s Global Shipping Programme. eBay determines eligibility, postage, customs charges, import taxes and final destination availability at checkout. The current programme list includes the countries below.
EU destinations
Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain and Sweden.
Non-EU destinations
Antigua and Barbuda
Aruba
Australia
Bahamas
Bahrain
Bangladesh
Barbados
Belize
Bermuda
Bolivia
Brazil
Brunei Darussalam
Cambodia
Canada
Cayman Islands
Chile
China
Colombia
Costa Rica
Dominica
Dominican Republic
Ecuador
Egypt
El Salvador
French Guiana
Grenada
Guadeloupe
Guatemala
Guernsey
Honduras
Hong Kong
Iceland
Indonesia
Israel
Jamaica
Japan
Jersey
Jordan
Kuwait
Liechtenstein
Macau
Malaysia
Maldives
Martinique
Mexico
Monaco
Montserrat
New Zealand
Nicaragua
Norway
Oman
Pakistan
Panama
Paraguay
Peru
Philippines
Qatar
Reunion
Saint Kitts and Nevis
Saint Lucia
Saudi Arabia
Singapore
South Africa
South Korea
Sri Lanka
Switzerland
Taiwan
Thailand
Trinidad and Tobago
Turks & Caicos Island
UAE
Ukraine
Uruguay
USA
Vietnam
How to find us / WhatsApp
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
VAT, returns and buyer protection
VAT treatment
VAT margin scheme / global accounting applies where eligible. VAT is not shown separately and is not reclaimable. This is the correct wording for a margin-scheme sale; it does not mean that the transaction is outside VAT rules.
Returns
Returns are handled through eBay under the return policy shown on this listing and do not restrict statutory rights. The exact item supplied must be returned complete, secure and in the same condition received.
Where eBay permits and a returned item has suffered measurable loss of value through installation, damage, alteration, missing parts or inadequate packaging, a deduction of up to 50% may be applied to reflect that loss. This is not an automatic fitment or restocking charge.
Careful dispatch
Orders are checked against the listing photographs, protected for transport and prepared for dispatch. Please review the part number and delivery address before checkout to help us get the correct component to the correct vehicle first time.
- Actual-item photographs retained for identification
- Connector and pedal body protected against impact
- Tracked services used where shown at checkout
- International processing handled by eBay for eligible programme orders
Support a local small business and reuse quality parts 🌍♻️
Every correctly matched used component keeps a serviceable part in use, reduces demand for additional manufacturing and helps lower the material, energy and transport burden associated with replacement parts. Your order supports a UK small business, local jobs and a practical circular economy.
Thank you for choosing ThePartPilot. Accurate VIN and photo matching helps customers order correctly first time, reduces avoidable returns and keeps more usable car parts out of waste streams. 🚗🔧📦