Vauxhall Opel Corsa E 2014-2019 Centre Dash Air Vents Hazard Switch 13377949
Vauxhall Opel Corsa E 2014-2019 Centre Dash Air Vents Hazard Switch 13377949
Centre Dashboard Air Vent Assembly With Hazard Switch Panel — 13377949
Actual Part, Reference Vehicle and Installed Location
The photographs below let you compare the housing, numbers, front finish and vehicle generation. The reference exterior is a five-door Corsa E; cross-referenced three-door and van applications are listed separately in the compatibility table.
Exact Compatibility Table
| Make / model | Body style | Years | Fitment status and required check |
|---|---|---|---|
| Vauxhall Corsa E (UK Mk4) | 3-door hatchback | 2014–2019 | Cross-referenced application when 13377949, finish, switch and connector match. |
| Vauxhall Corsa E (UK Mk4) | 5-door hatchback | 2014–2019 | Cross-referenced application when 13377949, finish, switch and connector match. |
| Vauxhall Corsavan E | 3-door van | 2014–2019 | Cross-referenced application; match number and dashboard finish before purchase. |
| Opel Corsa E (X15) | 3-door hatchback | 2014–2019 | Cross-referenced application when service number and configuration match. |
| Opel Corsa E (X15) | 5-door hatchback | 2014–2019 | Cross-referenced application when service number and configuration match. |
| Opel Corsa E Van / Sport Van | 3-door van | 2014–2019 | Cross-referenced application; match number, finish and connector. |
Known Non-Fitment — Please Do Not Order For These
| Vehicle / condition | Why it is excluded |
|---|---|
| Vauxhall / Opel Corsa D (approximately 2006/2007–2014) | Different dashboard generation. Some Corsa D vents can carry the same 464000934 mould-family number, so that number alone is not proof of compatibility. |
| Vauxhall / Opel Corsa F (2019 onward) | Completely different dashboard platform and vent design. |
| Adam, Astra, Meriva, Mokka and other models | No confirmed direct fit for this complete assembly. |
| Different trim finish, switch layout or connector | Do not order unless your original part and electrical connection match the photographs. |
| Different rear service number | Ask us through eBay Messages for a VIN / registration / photograph check before purchase. |
Part Numbers and Cross-Reference Guide
| Number | Meaning / use | Buyer instruction |
|---|---|---|
| 13377949 | Visible service / assembly number for the complete Corsa E centre vent unit. | Use as the primary number match. |
| 464000934 | Visible mould / casting-family number. | Do not use alone; it also appears on incompatible vent pieces. |
| 13384933 | Common catalogue and dismantler cross-reference for a Corsa E centre vent assembly. | Confirm appearance, switch and connector before treating as interchangeable. |
| 13363976 | Common reference for the hazard-switch module used with this vent family. | Check whether your required switch is included and identical. |
| 10093605 | Related supplier reference seen on some switch modules. | Secondary reference only; verify visually. |
What This Part Does and Where It Is Fitted
This assembly fits in the upper centre section of the dashboard, directly above the radio or infotainment display. Its twin adjustable vents direct heated, cooled or fresh HVAC airflow toward the centre of the cabin. The surrounding panel locates the vent mechanism and provides the factory-shaped aperture for the hazard-warning switch and associated indicator panel where fitted.
The vent housing does not generate heating or cooling itself; it controls the direction and distribution of air supplied by the vehicle's HVAC system. Correct clip geometry and sealing are important because a loose or distorted housing can rattle, leak air behind the dashboard or sit unevenly against the fascia.
Typical symptoms of a worn or damaged assembly
- Broken, missing or loose vent slats.
- Vent direction will not stay in the selected position.
- Reduced, obstructed or misdirected centre airflow.
- Rattling, buzzing or movement from the centre dashboard trim.
- Cracked, scratched or damaged decorative surround.
- Stiff or disconnected vent-control rollers/gears.
- Loose fascia caused by broken mounting clips.
- Intermittent hazard switch or indicator-panel operation where the included switch/module is at fault.
Why Choose a Factory-Original Used Part?
Low-cost copies can differ in plastic stiffness, clip depth, surface finish, vent gearing and switch aperture. A correctly matched factory-original used assembly is normally the most direct route to restoring the dashboard without compromising appearance or fit. Savings vary by part and market price.
Condition and Included Components
This is a used part and the actual item is shown in the listing photographs. Expect normal age-related marks consistent with removal, storage and previous use. Inspect every photograph closely for the exact cosmetic condition, clip arrangement, switch panel and connector.
Fitting Guide
These instructions are a general workshop guide for a competent fitter. Dashboard-trim fasteners and connector arrangements can vary by trim level. Stop if the panel does not release with light, even pressure.
Suggested tools
Installation sequence
- Park safely, switch off the ignition, remove the key and allow the vehicle's electrical systems to power down.
- Protect the dashboard and infotainment surround with a clean cloth or low-tack protective tape.
- Use plastic tools to release the centre-vent surround a little at a time. Work evenly around the perimeter; do not lever heavily from one corner.
- Draw the assembly forward only far enough to access the rear electrical connector(s).
- Release each connector locking tab and unplug by holding the connector body — never pull on the wires.
- Compare the old and replacement assemblies side by side: service number, finish, clips, foam seals, switch layout and connector must agree.
- Transfer an original compatible switch/module only if required and only after confirming the references and locking features match.
- Reconnect the electrical connector(s). Before fully clipping the panel home, test the hazard-warning switch, indicator illumination and vent movement.
- Align every locating clip and press the surround home with even hand pressure. Confirm that the panel sits flush with no trapped wiring.
- Carry out a final check for airflow direction, rattles, switch operation and secure fitment.
Estimated Repair Time and Static Labour Calculator
Typical workshop allowance: 0.5 to 1.0 labour hour (approximately 20–45 minutes for a competent fitter when no clips, wiring or adjacent trim require repair). This is an estimate, not a fixed quotation.
Formula: hourly labour rate × estimated billed hours = estimated labour charge.
| Garage rate | 0.5 hour | 0.75 hour | 1.0 hour |
|---|---|---|---|
| £50 per hour | £25 | £37.50 | £50 |
| £70 per hour | £35 | £52.50 | £70 |
| £90 per hour | £45 | £67.50 | £90 |
| £120 per hour | £60 | £90 | £120 |
No JavaScript is used. Diagnostic time, broken clips, damaged wiring, seized trim, coding requirements or additional repairs can increase the final charge. Fitting service is available subject to technician capacity, vehicle inspection and prior booking through eBay Messages.
ThePartPilot Service
Delivery, International Shipping and Checkout Address
UK delivery and international shipping are offered through the services enabled on this eBay listing. Global Shipping Programme / eBay International Shipping eligibility, cost, import charges and delivery options are controlled by eBay and confirmed at checkout.
Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden; Antigua and Barbuda, Aruba, Australia, Bahamas, Bahrain, Bangladesh, Barbados, Belize, Bermuda, Bolivia, Brazil, Brunei Darussalam, Cambodia, Canada, Cayman Islands, Chile, China, Colombia, Costa Rica, Dominica, Dominican Republic, Ecuador, Egypt, El Salvador, French Guiana, Grenada, Guadeloupe, Guatemala, Guernsey, Honduras, Hong Kong, Iceland, Indonesia, Israel, Jamaica, Japan, Jersey, Jordan, Kuwait, Liechtenstein, Macau, Malaysia, Maldives, Martinique, Mexico, Monaco, Montserrat, New Zealand, Nicaragua, Norway, Oman, Pakistan, Panama, Paraguay, Peru, Philippines, Qatar, Réunion, Saint Kitts and Nevis, Saint Lucia, Saudi Arabia, Singapore, South Africa, South Korea, Sri Lanka, Switzerland, Taiwan, Thailand, Trinidad and Tobago, Turks and Caicos Islands, United Arab Emirates, Ukraine, Uruguay, United States and Vietnam.
How to find us / WhatsApp
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Scan the QR code to open a WhatsApp chat for collections and enquiries.
If the QR image needs refreshing, generate it again from the same WhatsApp link.
Returns, Warranty and VAT Information
30-day warranty: the current listing includes a 30-day warranty. Any claim must be raised through eBay with the item details and supporting information.
Returns: all returns are handled through eBay and remain subject to eBay rules and the return terms displayed on the order. A refund deduction may apply only where eBay permits it and where the returned item has lost value through use, damage, missing parts or inadequate return packaging. No automatic fixed deduction applies merely because a buyer selected a particular return reason.
Fitment-related returns: check the photographs, number 13377949, trim finish, switch layout, connector and mounting points before purchase. We are happy to verify the details through eBay Messages when supplied with a VIN / registration and clear photographs.
VAT margin scheme / global accounting: eligible second-hand goods are sold under the applicable margin-scheme arrangements. VAT is not shown separately on the invoice and is not reclaimable as input tax.
Support a Local Small Business and Reuse Quality Parts
🚗 Choosing a correctly matched used factory part keeps a serviceable component in circulation, reduces demand for new raw materials and helps avoid the energy and packaging associated with manufacturing a replacement from scratch.
♻️ Your purchase supports a local automotive-parts business, skilled dismantling, careful checking, shelf storage and secure dispatch. Ordering by number and photograph helps us reduce unnecessary transport and returns — better for the customer, the business and the environment.